On 06/29/2018 12:28 PM, Mike Rapoport wrote: > Hi Randy, > > On Fri, Jun 29, 2018 at 09:34:55AM -0700, Randy Dunlap wrote: >> On 06/29/2018 06:42 AM, Mike Rapoport wrote: >>> Otherwise mm configuration options show up in the top level menu. >>> >>> Signed-off-by: Mike Rapoport <[email protected]> >> >> Hi Mike, >> >> In which config tool does this matter? >> >> For xconfig, it seems to me that this patch hides the MM menu, whereas >> before this patch, the MM menu is easy to find (although it could >> use some kind of heading). > > With xconfig the menu gets into the top right pane when you click on "ARC > architecture configuration", similar to what one gets on x86 with > "Processor type and features" or "Kernel features" on ARM. > > With menuconfig it looks a bit more prominent, note that mm options are > between "ARC Architecture Configuration" and "Networking support":
I know. I ran all 4 of menuconfig, nconfig, xconfig, and gconfig. I would prefer to see Memory Management options have its own top-level menu, but that's a different patch. Then menuconfig would look like this: │ │ *** Compiler: arc-linux-gcc (GCC) 8.1.0 *** │ │ │ │ General setup ---> │ │ │ │ [*] Enable loadable module support ---> │ │ │ │ [*] Enable the block layer ---> │ │ │ │ ARC Architecture Configuration ---> │ │ │ │ Memory Management options ---> │ │ │ │ (11) Maximum zone order │ │ │ │ [*] Networking support ---> │ │ │ │ Device Drivers ---> │ │ │ │ Bus Support ---> but that "Maximum zone order" needs to be moved or taken care of somehow. [snip] > > > >>> default "12" if ARC_HUGEPAGE_16M >>> default "11" >>> >>> +endmenu # "ARC Architecture Configuration" >>> + >>> source "net/Kconfig" >>> source "drivers/Kconfig" thanks, -- ~Randy
