[PATCH 2/8] ARM: dts: imx6q-apalis-eval: add carrier board 3.3V supply

[Stefan Agner]

Add the 3.3V main supply on the carrier board. Currently as a fixed
supply since not all consumer are modeled yet. This gets also rid of
some missing supply warnings.

Signed-off-by: Stefan Agner <ste...@agner.ch>
---
 arch/arm/boot/dts/imx6q-apalis-eval.dts | 12 ++++++++++++
 1 file changed, 12 insertions(+)

diff --git a/arch/arm/boot/dts/imx6q-apalis-eval.dts 
b/arch/arm/boot/dts/imx6q-apalis-eval.dts
index 621d9709effa..707ac9a46115 100644
--- a/arch/arm/boot/dts/imx6q-apalis-eval.dts
+++ b/arch/arm/boot/dts/imx6q-apalis-eval.dts
@@ -113,6 +113,7 @@
                 */
                compatible = "edt,et057090dhu";
                backlight = <&backlight>;
+               power-supply = <&reg_3v3_sw>;
 
                port {
                        lcd_panel_in: endpoint {
@@ -131,19 +132,30 @@
                enable-active-high;
                status = "okay";
        };
+
+       reg_3v3_sw: regulator-3v3-sw {
+               compatible = "regulator-fixed";
+               regulator-name = "3.3V_SW";
+               regulator-min-microvolt = <3300000>;
+               regulator-max-microvolt = <3300000>;
+               regulator-always-on;
+       };
 };
 
 &backlight {
        brightness-levels = <0 127 191 223 239 247 251 255>;
        default-brightness-level = <1>;
+       power-supply = <&reg_3v3_sw>;
        status = "okay";
 };
 
 &can1 {
+       xceiver-supply = <&reg_3v3_sw>;
        status = "okay";
 };
 
 &can2 {
+       xceiver-supply = <&reg_3v3_sw>;
        status = "okay";
 };
 
-- 
2.18.0