Hi Sean,
>>> Adding an independent btuart.h header allows these essential definitions
>>> can be reused in vendor driver. Also, struct btuart_vnd is extended with
>>> additional callbacks such as .init initializing vendor data, .shtudown,
>>> .recv and .send supporting SoC specific framing for that btuart can
>>> simply adapt to various Bluetooth uart-based devices.
>>>
>>> Signed-off-by: Sean Wang <sean.w...@mediatek.com>
>>> ---
>>> drivers/bluetooth/btuart.c | 73
>>> ++++++++++++++++++++++++----------------------
>>> drivers/bluetooth/btuart.h | 30 +++++++++++++++++++
>>> 2 files changed, 68 insertions(+), 35 deletions(-)
>>> create mode 100644 drivers/bluetooth/btuart.h
>>>
>>> diff --git a/drivers/bluetooth/btuart.c b/drivers/bluetooth/btuart.c
>>> index a900aac..65d0086 100644
>>> --- a/drivers/bluetooth/btuart.c
>>> +++ b/drivers/bluetooth/btuart.c
>>> @@ -33,35 +33,11 @@
>>> #include <net/bluetooth/hci_core.h>
>>>
>>> #include "h4_recv.h"
>>> +#include "btuart.h"
>>> #include "btbcm.h"
>>>
>>> #define VERSION "1.0"
>>>
>>> -struct btuart_vnd {
>>> - const struct h4_recv_pkt *recv_pkts;
>>> - int recv_pkts_cnt;
>>> - unsigned int manufacturer;
>>> - int (*open)(struct hci_dev *hdev);
>>> - int (*close)(struct hci_dev *hdev);
>>> - int (*setup)(struct hci_dev *hdev);
>>> -};
>>> -
>>> -struct btuart_dev {
>>> - struct hci_dev *hdev;
>>> - struct serdev_device *serdev;
>>> -
>>> - struct work_struct tx_work;
>>> - unsigned long tx_state;
>>> - struct sk_buff_head txq;
>>> -
>>> - struct sk_buff *rx_skb;
>>> -
>>> - const struct btuart_vnd *vnd;
>>> -};
>>
>> I really like to avoid this since it is not clean. Frankly I prefer to keep
>> the btuart.c driver for drivers that really just use H:4 as transport
>> protocol. If the protocol is only H:4 alike and has extra headers, then it
>> should be a separate driver.
>>
>
> thanks for letting me know your concern. I think I'm a little over in reusing
> these existing methods and break something generic and its beauty.
>
> I'll make the driver be a separate one based on btuart in the next version.
>
>
>> The common H:4 handling is abstracted in h4_recv.h already anyway and we can
>> add more pieces if needed. However I also wonder since you have extra
>> framing that the complex H:4 state keeping might be not needed at all. So it
>> could be simplified.
>>
>
> okay, I will get rid of h4_recv.h and consider to use more simplified logic
> to handle the extra framing and its payload.
only if it is already framed by your extra header, but I seem to recall that it
will frame it. For example the bfusb.c old driver does frame H:4 as well and
then no extra state keeping for H:4 is needed. Just pass the frames up into the
core via hci_recv_frame (or hci_recv_diag for vendor diagnostic) and move on
with it.
You can of course use h4_recv.h if you need to, but only do that if you are
true H:4 stream and have no idea where a frame ends and starts.
Regards
Marcel
