For all 96Boards, the following standard is used for onboard LEDs.
device-name:green:user1 default-trigger: heartbeat
device-name:green:user2 default-trigger: mmc0/disk-activity
(onboard-storage)
device-name:green:user3 default-trigger: mmc1 (SD-card)
device-name:green:user4 default-trigger: none, panic-indicator
device-name:yellow:wlan default-trigger: phy0tx
device-name:blue:bt default-trigger: hci0-power
So lets adopt the same for Poplar, which is one of the 96Boards
Enterprise edition platform.
Due to absence of WLAN and BT support, corresponding LED nodes are not
considered.
Signed-off-by: Manivannan Sadhasivam <[email protected]>
---
.../arm64/boot/dts/hisilicon/hi3798cv200-poplar.dts | 13 +++++++------
1 file changed, 7 insertions(+), 6 deletions(-)
diff --git a/arch/arm64/boot/dts/hisilicon/hi3798cv200-poplar.dts
b/arch/arm64/boot/dts/hisilicon/hi3798cv200-poplar.dts
index d30f6eb8a5ee..f6f3e928a54e 100644
--- a/arch/arm64/boot/dts/hisilicon/hi3798cv200-poplar.dts
+++ b/arch/arm64/boot/dts/hisilicon/hi3798cv200-poplar.dts
@@ -35,30 +35,31 @@
compatible = "gpio-leds";
user-led0 {
- label = "USER-LED0";
+ label = "hi3798cv200-poplar:green:user1";
gpios = <&gpio6 3 GPIO_ACTIVE_LOW>;
linux,default-trigger = "heartbeat";
default-state = "off";
};
user-led1 {
- label = "USER-LED1";
+ label = "hi3798cv200-poplar:green:user2";
gpios = <&gpio5 1 GPIO_ACTIVE_LOW>;
linux,default-trigger = "mmc0";
default-state = "off";
};
user-led2 {
- label = "USER-LED2";
+ label = "hi3798cv200-poplar:green:user3";
gpios = <&gpio5 2 GPIO_ACTIVE_LOW>;
- linux,default-trigger = "none";
+ linux,default-trigger = "mmc1";
default-state = "off";
};
user-led3 {
- label = "USER-LED3";
+ label = "hi3798cv200-poplar:green:user4";
gpios = <&gpio10 6 GPIO_ACTIVE_LOW>;
- linux,default-trigger = "cpu0";
+ linux,default-trigger = "none";
+ panic-indicator;
default-state = "off";
};
};
--
2.17.1
