For all 96Boards, the following standard is used for onboard LEDs.
device-name:green:user1 default-trigger: heartbeat
device-name:green:user2 default-trigger: mmc0/disk-activity
(onboard-storage)
device-name:green:user3 default-trigger: mmc1 (SD-card)
device-name:green:user4 default-trigger: none, panic-indicator
device-name:yellow:wlan default-trigger: phy0tx
device-name:blue:bt default-trigger: hci0-power
So lets adopt the same for Ultra96, which is one of the 96Boards
CE and AI platform. Since the WLAN and BT LEDs are hardwired onboard,
consolidate only User LEDs.
Signed-off-by: Manivannan Sadhasivam <[email protected]>
---
arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts | 15 ++++++++-------
1 file changed, 8 insertions(+), 7 deletions(-)
diff --git a/arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts
b/arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts
index eb5e8bddb610..565ceb390f99 100644
--- a/arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts
+++ b/arch/arm64/boot/dts/xilinx/zynqmp-zcu100-revC.dts
@@ -57,29 +57,30 @@
leds {
compatible = "gpio-leds";
ds2 {
- label = "ds2";
+ label = "zynqmp-zcu100-revC:green:user1";
gpios = <&gpio 20 GPIO_ACTIVE_HIGH>;
linux,default-trigger = "heartbeat";
};
ds3 {
- label = "ds3";
+ label = "zynqmp-zcu100-revC:green:user2";
gpios = <&gpio 19 GPIO_ACTIVE_HIGH>;
- linux,default-trigger = "phy0tx"; /* WLAN tx */
+ linux,default-trigger = "mmc0";
default-state = "off";
};
ds4 {
- label = "ds4";
+ label = "zynqmp-zcu100-revC:green:user3";
gpios = <&gpio 18 GPIO_ACTIVE_HIGH>;
- linux,default-trigger = "phy0rx"; /* WLAN rx */
+ linux,default-trigger = "mmc1";
default-state = "off";
};
ds5 {
- label = "ds5";
+ label = "zynqmp-zcu100-revC:green:user4";
gpios = <&gpio 17 GPIO_ACTIVE_HIGH>;
- linux,default-trigger = "bluetooth-power";
+ linux,default-trigger = "none";
+ panic-indicator;
};
vbus_det { /* U5 USB5744 VBUS detection via MIO25 */
--
2.17.1
