On Mon, Dec 24, 2018 at 8:25 PM <chuanjia....@mediatek.com> wrote: > > From: Chuanjia Liu <chuanjia....@mediatek.com> >
there are still some nitpicks an empty char should follow the ':' char > Virtual gpio only used inside SOC and not being exported to outside SOC. > Some modules use virtual gpio as eint and doesn't nedd SMT. s/nedd/need/ > So this patch add EINT support to virtual GPIOs. > > Signed-off-by: Chuanjia Liu <chuanjia....@mediatek.com> > --- > change note: > v3 : 1. modify subject and description > 2. modify comments > --- > drivers/pinctrl/mediatek/pinctrl-mtk-common-v2.c | 10 +++++++++- > 1 file changed, 9 insertions(+), 1 deletion(-) > > diff --git a/drivers/pinctrl/mediatek/pinctrl-mtk-common-v2.c > b/drivers/pinctrl/mediatek/pinctrl-mtk-common-v2.c > index 4a9e0d4c2bbc..a0db145f798d 100644 > --- a/drivers/pinctrl/mediatek/pinctrl-mtk-common-v2.c > +++ b/drivers/pinctrl/mediatek/pinctrl-mtk-common-v2.c > @@ -290,7 +290,15 @@ static int mtk_xt_set_gpio_as_eint(void *data, unsigned > long eint_n) > return err; > > err = mtk_hw_set_value(hw, desc, PINCTRL_PIN_REG_SMT, MTK_ENABLE); > - if (err) > + /* merge the second line to be consistent with the other comment blocks > + *SMT is supposed to be supported by every real GPIO and doesn't an empty char should follow '*' char to be consistent with the other comment blocks and also in the other lines starting with '*' > + *support virtual GPIOs, so the extra condition err != -ENOTSUPP > + *is just for adding EINT support to these virtual GPIOs. It should > + *add an extra flag in the pin descriptor when more pins with > + *distinctive characteristic come out. > + */ > + remove the blank line > + if (err && err != -ENOTSUPP) > return err; > > return 0; > -- > 2.19.1 >
