On 01/28/2019 07:49 AM, Vignesh R wrote:
> Cadence OSPI controller IP supports Octal IO (x8 IO lines),
> It also has an integrated PHY. IP register layout is very
> similar to existing QSPI IP except for additional bits to support Octal
> and Octal DDR mode. Therefore, extend current driver to support Octal
> mode. Only Octal SDR read (1-1-8)mode is supported for now.
>
> Tested with mt35xu512aba Octal flash on TI's AM654 EVM.
>
> Signed-off-by: Vignesh R <vigne...@ti.com>
> Reviewed-by: Tudor Ambarus <tudor.amba...@microchip.com>
> ---
>
> v5:
> s/cqsi_base_hwcaps_mask/CQSPI_BASE_HWCAPS_MASK/g
> Add back cqspi_driver_platdata definition for base compatible.
>
> v4: Fix comments by Tudor on v3
> v3: No changes
> v2: Declare Octal mode capability based on compatible.
>
> drivers/mtd/spi-nor/cadence-quadspi.c | 58 +++++++++++++++++++++------
> 1 file changed, 46 insertions(+), 12 deletions(-)
>
> diff --git a/drivers/mtd/spi-nor/cadence-quadspi.c
> b/drivers/mtd/spi-nor/cadence-quadspi.c
> index 04cedd3a2bf6..c8113ebe44fd 100644
> --- a/drivers/mtd/spi-nor/cadence-quadspi.c
> +++ b/drivers/mtd/spi-nor/cadence-quadspi.c
> @@ -44,6 +44,12 @@
> /* Quirks */
> #define CQSPI_NEEDS_WR_DELAY BIT(0)
>
> +/* Capabilities mask */
> +#define CQSPI_BASE_HWCAPS_MASK \
> + (SNOR_HWCAPS_READ | SNOR_HWCAPS_READ_FAST | \
> + SNOR_HWCAPS_READ_1_1_2 | SNOR_HWCAPS_READ_1_1_4 | \
> + SNOR_HWCAPS_PP)
> +
> struct cqspi_st;
>
> struct cqspi_flash_pdata {
> @@ -93,6 +99,11 @@ struct cqspi_st {
> struct cqspi_flash_pdata f_pdata[CQSPI_MAX_CHIPSELECT];
> };
>
> +struct cqspi_driver_platdata {
> + u32 hwcaps_mask;
> + u8 quirks;
> +};
> +
> /* Operation timeout value */
> #define CQSPI_TIMEOUT_MS 500
> #define CQSPI_READ_TIMEOUT_MS 10
> @@ -101,6 +112,7 @@ struct cqspi_st {
> #define CQSPI_INST_TYPE_SINGLE 0
> #define CQSPI_INST_TYPE_DUAL 1
> #define CQSPI_INST_TYPE_QUAD 2
> +#define CQSPI_INST_TYPE_OCTAL 3
>
> #define CQSPI_DUMMY_CLKS_PER_BYTE 8
> #define CQSPI_DUMMY_BYTES_MAX 4
> @@ -911,6 +923,9 @@ static int cqspi_set_protocol(struct spi_nor *nor, const
> int read)
> case SNOR_PROTO_1_1_4:
> f_pdata->data_width = CQSPI_INST_TYPE_QUAD;
> break;
> + case SNOR_PROTO_1_1_8:
> + f_pdata->data_width = CQSPI_INST_TYPE_OCTAL;
> + break;
> default:
> return -EINVAL;
> }
> @@ -1213,21 +1228,22 @@ static void cqspi_request_mmap_dma(struct cqspi_st
> *cqspi)
>
> static int cqspi_setup_flash(struct cqspi_st *cqspi, struct device_node *np)
> {
> - const struct spi_nor_hwcaps hwcaps = {
> - .mask = SNOR_HWCAPS_READ |
> - SNOR_HWCAPS_READ_FAST |
> - SNOR_HWCAPS_READ_1_1_2 |
> - SNOR_HWCAPS_READ_1_1_4 |
> - SNOR_HWCAPS_PP,
> - };
> struct platform_device *pdev = cqspi->pdev;
> struct device *dev = &pdev->dev;
> + const struct cqspi_driver_platdata *ddata;
> + struct spi_nor_hwcaps hwcaps;
> struct cqspi_flash_pdata *f_pdata;
> struct spi_nor *nor;
> struct mtd_info *mtd;
> unsigned int cs;
> int i, ret;
>
> + ddata = of_device_get_match_data(dev);
> + if (!ddata)
> + hwcaps.mask = CQSPI_BASE_HWCAPS_MASK;
Now that .data is set in all cqspi_dt_ids[], maybe it's better to print a
message and return an error here. But I guess it's a matter of taste, so not a
show stopper.
> + else
> + hwcaps.mask = ddata->hwcaps_mask;
> +
> /* Get flash device data */
> for_each_available_child_of_node(dev->of_node, np) {
> ret = of_property_read_u32(np, "reg", &cs);
> @@ -1310,7 +1326,7 @@ static int cqspi_probe(struct platform_device *pdev)
> struct cqspi_st *cqspi;
> struct resource *res;
> struct resource *res_ahb;
> - unsigned long data;
> + const struct cqspi_driver_platdata *ddata;
> int ret;
> int irq;
>
> @@ -1377,8 +1393,8 @@ static int cqspi_probe(struct platform_device *pdev)
> }
>
> cqspi->master_ref_clk_hz = clk_get_rate(cqspi->clk);
> - data = (unsigned long)of_device_get_match_data(dev);
> - if (data & CQSPI_NEEDS_WR_DELAY)
> + ddata = of_device_get_match_data(dev);
> + if (ddata && (ddata->quirks & CQSPI_NEEDS_WR_DELAY))
> cqspi->wr_delay = 5 * DIV_ROUND_UP(NSEC_PER_SEC,
> cqspi->master_ref_clk_hz);
>
> @@ -1460,14 +1476,32 @@ static const struct dev_pm_ops cqspi__dev_pm_ops = {
> #define CQSPI_DEV_PM_OPS NULL
> #endif
>
> +static const struct cqspi_driver_platdata cdns_qspi = {
> + .hwcaps_mask = CQSPI_BASE_HWCAPS_MASK,
> +};
> +
> +static const struct cqspi_driver_platdata k2g_qspi = {
> + .hwcaps_mask = CQSPI_BASE_HWCAPS_MASK,
> + .quirks = CQSPI_NEEDS_WR_DELAY,
> +};
> +
> +static const struct cqspi_driver_platdata am654_ospi = {
> + .hwcaps_mask = CQSPI_BASE_HWCAPS_MASK | SNOR_HWCAPS_READ_1_1_8,
> + .quirks = CQSPI_NEEDS_WR_DELAY,
> +};
> +
> static const struct of_device_id cqspi_dt_ids[] = {
> {
> .compatible = "cdns,qspi-nor",
> - .data = (void *)0,
> + .data = &cdns_qspi,
> },
> {
> .compatible = "ti,k2g-qspi",
> - .data = (void *)CQSPI_NEEDS_WR_DELAY,
> + .data = &k2g_qspi,
> + },
> + {
> + .compatible = "ti,am654-ospi",
> + .data = &am654_ospi,
> },
> { /* end of table */ }
> };
>
