On Wed, Mar 13, 2019 at 10:27:22AM -0500, [email protected] wrote:
> From: Thor Thayer <[email protected]>
>
> Stratix10 Double Bit Error Address was always read from
> SDRAM Address register instead of each device's Address
> register.
> To determine which device had the DBE, cycle through
> the EDAC devices comparing the DBE value to the db_irq
> value. Once found, report the DBE Address from the device
> registers as well as the device name.
> Finally, notify the system via an SMC call and indicate
> the panic should result in a system reboot.
> Change a run-time check to a Stratix10 compile-time check
> for a clean SMC notification.
>
> Fixes: d5fc9125566c ("EDAC, altera: Combine Stratix10 and Arria10 probe
> functions")
> Signed-off-by: Thor Thayer <[email protected]>
> ---
> drivers/edac/altera_edac.c | 69
> ++++++++++++++++++++++++++++++++++------------
> drivers/edac/altera_edac.h | 20 ++++++++++++++
> 2 files changed, 72 insertions(+), 17 deletions(-)
Applied, thanks.
--
Regards/Gruss,
Boris.
Good mailing practices for 400: avoid top-posting and trim the reply.
