This change replaces the use of the `delay_usecs` field with the new
`delay` field. The code/test still uses micro-seconds, but they are now
configured and used via the `struct spi_delay` format of the `delay` field.

Signed-off-by: Alexandru Ardelean <alexandru.ardel...@analog.com>
---
 drivers/spi/spi-loopback-test.c | 12 +++++++++---
 1 file changed, 9 insertions(+), 3 deletions(-)

diff --git a/drivers/spi/spi-loopback-test.c b/drivers/spi/spi-loopback-test.c
index 6f18d4952767..b6d79cd156fb 100644
--- a/drivers/spi/spi-loopback-test.c
+++ b/drivers/spi/spi-loopback-test.c
@@ -298,12 +298,18 @@ static struct spi_test spi_tests[] = {
                        {
                                .tx_buf = TX(0),
                                .rx_buf = RX(0),
-                               .delay_usecs = 1000,
+                               .delay = {
+                                       .value = 1000,
+                                       .unit = SPI_DELAY_UNIT_USECS,
+                               },
                        },
                        {
                                .tx_buf = TX(0),
                                .rx_buf = RX(0),
-                               .delay_usecs = 1000,
+                               .delay = {
+                                       .value = 1000,
+                                       .unit = SPI_DELAY_UNIT_USECS,
+                               },
                        },
                },
        },
@@ -537,7 +543,7 @@ static int spi_test_check_elapsed_time(struct spi_device 
*spi,
                unsigned long long nbits = (unsigned long long)BITS_PER_BYTE *
                                           xfer->len;
 
-               delay_usecs += xfer->delay_usecs;
+               delay_usecs += xfer->delay.value;
                if (!xfer->speed_hz)
                        continue;
                estimated_time += div_u64(nbits * NSEC_PER_SEC, xfer->speed_hz);
-- 
2.20.1

Reply via email to