Hello, here is a patchset updating the existing max1027.c driver (for 10-bit max1027/29/31 ADCs) with a few corrections/improvements and then introducing their 12-bit cousins named max1227/29/31.
As on my hardware setup the "start conversion" and "end of conversion" pin are not wired (which is absolutely fine for this chip), I also updated the driver and the bindings to support optional interrupts. In this case, triggered buffers are not available and the user must poll the value from sysfs. Thanks, Miquèl Miquel Raynal (7): iio: adc: max1027: Add debugfs register read support iio: adc: max1027: Make it optional to use interrupts iio: adc: max1027: Reset the device at probe time iio: adc: max1027: Prepare the introduction of different resolutions iio: adc: max1027: Introduce 12-bit devices support dt-bindings: iio: adc: max1027: Mark interrupts as optional dt-bindings: iio: adc: max1027: Document max12xx series compatibles .../bindings/iio/adc/max1027-adc.txt | 12 +- drivers/iio/adc/Kconfig | 4 +- drivers/iio/adc/max1027.c | 190 +++++++++++------- 3 files changed, 133 insertions(+), 73 deletions(-) -- 2.20.1
