From: Bjorn Helgaas <[email protected]> Per PCIe r5.0 sec 7.5.2.1, PME may be generated from D0, so update Documentation/power/pci.rst to reflect that.
Signed-off-by: Bjorn Helgaas <[email protected]> --- Documentation/power/pci.rst | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/Documentation/power/pci.rst b/Documentation/power/pci.rst index db41a770a2f5..a90e82c70a3b 100644 --- a/Documentation/power/pci.rst +++ b/Documentation/power/pci.rst @@ -130,8 +130,8 @@ a full power-on reset sequence and the power-on defaults are restored to the device by hardware just as at initial power up. PCI devices supporting the PCI PM Spec can be programmed to generate PMEs -while in a low-power state (D1-D3), but they are not required to be capable -of generating PMEs from all supported low-power states. In particular, the +while in any power state (D0-D3), but they are not required to be capable +of generating PMEs from all supported power states. In particular, the capability of generating PMEs from D3cold is optional and depends on the presence of additional voltage (3.3Vaux) allowing the device to remain sufficiently active to generate a wakeup signal. -- 2.23.0.700.g56cf767bdb-goog
