[PATCH] spi: Fix SPI_CS_HIGH setting when using native and GPIO CS

[Gregory CLEMENT]

When improving the CS GPIO support at core level, the SPI_CS_HIGH
has been enabled for all the CS lines used for a given SPI controller.

However, the SPI framework allows to have on the same controller native
CS and GPIO CS. The native CS may not support the SPI_CS_HIGH, so they
should not be setup automatically.

With this patch the setting is done only for the CS that will use a
GPIO as CS

Fixes: f3186dd87669 ("spi: Optionally use GPIO descriptors for CS GPIOs")
Cc: <sta...@vger.kernel.org>
Signed-off-by: Gregory CLEMENT <gregory.clem...@bootlin.com>
---
 drivers/spi/spi.c | 18 +++++++++---------
 1 file changed, 9 insertions(+), 9 deletions(-)

diff --git a/drivers/spi/spi.c b/drivers/spi/spi.c
index 5414a10afd65..1b68acc28c8f 100644
--- a/drivers/spi/spi.c
+++ b/drivers/spi/spi.c
@@ -1880,15 +1880,7 @@ static int of_spi_parse_dt(struct spi_controller *ctlr, 
struct spi_device *spi,
                spi->mode |= SPI_3WIRE;
        if (of_property_read_bool(nc, "spi-lsb-first"))
                spi->mode |= SPI_LSB_FIRST;
-
-       /*
-        * For descriptors associated with the device, polarity inversion is
-        * handled in the gpiolib, so all chip selects are "active high" in
-        * the logical sense, the gpiolib will invert the line if need be.
-        */
-       if (ctlr->use_gpio_descriptors)
-               spi->mode |= SPI_CS_HIGH;
-       else if (of_property_read_bool(nc, "spi-cs-high"))
+       if (of_property_read_bool(nc, "spi-cs-high"))
                spi->mode |= SPI_CS_HIGH;
 
        /* Device DUAL/QUAD mode */
@@ -1952,6 +1944,14 @@ static int of_spi_parse_dt(struct spi_controller *ctlr, 
struct spi_device *spi,
        }
        spi->chip_select = value;
 
+       /*
+        * For descriptors associated with the device, polarity inversion is
+        * handled in the gpiolib, so all gpio chip selects are "active high"
+        * in the logical sense, the gpiolib will invert the line if need be.
+        */
+       if ((ctlr->use_gpio_descriptors) && ctlr->cs_gpiods[spi->chip_select])
+               spi->mode |= SPI_CS_HIGH;
+
        /* Device speed */
        rc = of_property_read_u32(nc, "spi-max-frequency", &value);
        if (rc) {
-- 
2.23.0