Met vriendelijke groet / kind regards,
Mike Looijmans
System Expert
TOPIC Embedded Products B.V.
Materiaalweg 4, 5681 RJ Best
The Netherlands
T: +31 (0) 499 33 69 69
E: mike.looijm...@topicproducts.com
W: www.topicproducts.com
Please consider the environment before printing this e-mail
On 29-05-2020 23:08, Rob Herring wrote:
On Fri, May 29, 2020 at 08:00:45AM +0200, Mike Looijmans wrote:
This enables support for VBUS on boards where the power is supplied
by a regulator. The regulator is enabled when the USB port enters
HOST mode.
Signed-off-by: Mike Looijmans <mike.looijm...@topic.nl>
---
v2: Added missing "return 0;" in set_vbus method
.../devicetree/bindings/usb/usb-nop-xceiv.txt | 3 ++
drivers/usb/phy/phy-generic.c | 46 ++++++++++++++++++-
drivers/usb/phy/phy-generic.h | 2 +
3 files changed, 50 insertions(+), 1 deletion(-)
diff --git a/Documentation/devicetree/bindings/usb/usb-nop-xceiv.txt
b/Documentation/devicetree/bindings/usb/usb-nop-xceiv.txt
index 4dc6a8ee3071..775a19fdb613 100644
--- a/Documentation/devicetree/bindings/usb/usb-nop-xceiv.txt
+++ b/Documentation/devicetree/bindings/usb/usb-nop-xceiv.txt
@@ -16,6 +16,9 @@ Optional properties:
- vcc-supply: phandle to the regulator that provides power to the PHY.
+- vbus-supply: phandle to the regulator that provides the VBUS power for when
+ the device is in HOST mode.
+
I'm going to say no to expanding this binding...
First, there sure are a lot of controls on a NOP tranceiver.
Second, unless Vbus is supplying the PHY, then this belongs in a
connector node for which this is already supported.
Clear, I moved the implementation to the DWC3 driver and will submit a
new patch for that.
- reset-gpios: Should specify the GPIO for reset.
- vbus-detect-gpio: should specify the GPIO detecting a VBus insertion
--
Mike Looijmans