The chip is hardwired to the board's PCIe bus and needs to be properly
setup trough a firmware routine after a PCI fundamental reset. Pass the
reset controller phandle that takes care of triggering the
initialization to the relevant PCI device.
Signed-off-by: Nicolas Saenz Julienne <nsaenzjulie...@suse.de>
---
arch/arm/boot/dts/bcm2711-rpi-4-b.dts | 7 +++++++
1 file changed, 7 insertions(+)
diff --git a/arch/arm/boot/dts/bcm2711-rpi-4-b.dts
b/arch/arm/boot/dts/bcm2711-rpi-4-b.dts
index 47e7c9c14ddf..2646c858449f 100644
--- a/arch/arm/boot/dts/bcm2711-rpi-4-b.dts
+++ b/arch/arm/boot/dts/bcm2711-rpi-4-b.dts
@@ -207,6 +207,13 @@ phy1: ethernet-phy@1 {
};
};
+&pcie0 {
+ usb@1,0 {
+ reg = <0 0 0 0 0>;
+ resets = <&usb_reset>;
+ };
+};
+
/* uart0 communicates with the BT module */
&uart0 {
pinctrl-names = "default";
--
2.26.2
