Hi Suresh,
Thanks for your patch.
On 2020-06-18 19:34:31 +0900, Suresh Udipi wrote:
> Add a warning message when the selected PHY speed is less
> than supported minimum PHY speed given in the hsfreq table[1].
>
> For raspberry pi camera capture on Kingfisher board with resolution
> 640x480, the calculated PHY speed is 48 mbps which is less than
> the minimum PHY speed 80 Mbps from the table[1]. But in this cases
> capture is successful.
>
> [1] specs r19uh0105ej0200-r-car-3rd-generation.pdf [Table 25.9]
>
> Signed-off-by: Suresh Udipi <sud...@jp.adit-jv.com>
> Signed-off-by: Michael Rodin <mro...@de.adit-jv.com>
Reviewed-by: Niklas Söderlund <niklas.soderlund+rene...@ragnatech.se>
> ---
> drivers/media/platform/rcar-vin/rcar-csi2.c | 4 ++++
> 1 file changed, 4 insertions(+)
>
> diff --git a/drivers/media/platform/rcar-vin/rcar-csi2.c
> b/drivers/media/platform/rcar-vin/rcar-csi2.c
> index f18dedc..1184527 100644
> --- a/drivers/media/platform/rcar-vin/rcar-csi2.c
> +++ b/drivers/media/platform/rcar-vin/rcar-csi2.c
> @@ -433,6 +433,10 @@ static int rcsi2_set_phypll(struct rcar_csi2 *priv,
> unsigned int mbps)
> const struct rcsi2_mbps_reg *hsfreq;
> const struct rcsi2_mbps_reg *hsfreq_prev = NULL;
>
> + if (mbps < priv->info->hsfreqrange->mbps)
> + dev_warn(priv->dev, "%u Mbps less than min PHY speed %u Mbps",
> + mbps, priv->info->hsfreqrange->mbps);
> +
> for (hsfreq = priv->info->hsfreqrange; hsfreq->mbps != 0; hsfreq++) {
> if (hsfreq->mbps >= mbps)
> break;
> --
> 2.7.4
>
--
Regards,
Niklas Söderlund
