15.07.2020 07:20, Sowjanya Komatineni пишет:
> SW can trigger MIPI pads calibration any time after power on
> but calibration results will be latched and applied to the pads
> by MIPI CAL unit only when the link is in LP-11 state and then
> status register will be updated.
>
> For CSI, trigger of pads calibration happen during CSI stream
> enable where CSI receiver is kept ready prior to sensor or CSI
> transmitter stream start.
>
> So, pads may not be in LP-11 at this time and waiting for the
> calibration to be done immediate after calibration start will
> result in timeout.
>
> This patch splits tegra_mipi_calibrate() and tegra_mipi_wait()
> so triggering for calibration and waiting for it to complete can
> happen at different stages.
>
> Signed-off-by: Sowjanya Komatineni <skomatin...@nvidia.com>
> ---
...
> int tegra_mipi_calibrate(struct tegra_mipi_device *device)
> {
> @@ -370,12 +381,10 @@ int tegra_mipi_calibrate(struct tegra_mipi_device
> *device)
> value |= MIPI_CAL_CTRL_START;
> tegra_mipi_writel(device->mipi, value, MIPI_CAL_CTRL);
>
> - err = tegra_mipi_wait(device->mipi);
Doesn't MIPI clock need to be enabled during of the calibration process?
> mutex_unlock(&device->mipi->lock);
> clk_disable(device->mipi->clk);
>
> - return err;
> + return 0;
> }
> EXPORT_SYMBOL(tegra_mipi_calibrate);
