Hi Tamseel,

> -----Original Message-----
> From: Tamseel Shams <[email protected]>
> Sent: 10 August 2020 08:30
> To: [email protected]; [email protected]; [email protected];
> [email protected]
> Cc: [email protected]; [email protected];
> [email protected]; [email protected];
> [email protected]; Tamseel Shams <[email protected]>
> Subject: [RFT PATCH v5] serial: samsung: Removes the IRQ not found warning
> 
> In few older Samsung SoCs like s3c2410, s3c2412 and s3c2440, UART IP is having
> 2 interrupt lines.
> However, in other SoCs like s3c6400, s5pv210, exynos5433, and exynos4210
> UART is having only 1 interrupt line. Due to this, "platform_get_irq(platdev, 
> 1)"
> call in the driver gives the following false-positive error:
> "IRQ index 1 not found" on newer SoC's.
> 
> This patch adds the condition to check for Tx interrupt only for the those 
> SoC's
> which have 2 interrupt lines.
> 
> Signed-off-by: Tamseel Shams <[email protected]>
> ---
Tested on exynos7 platform, don’t see " IRQ index 1 not found" with this patch 
applied
Fill free to added 
Tested-by: Alim Akhtar <[email protected]>
Reviewed-by: Alim Akhtar <[email protected]>

> Commit message is changed.
> 
> Added RFT, for older platform.
> 
> Addressed Krzysztof's review comments [1] [1] ->
> https://lkml.org/lkml/2020/7/21/150
> 
>  drivers/tty/serial/samsung_tty.c | 8 +++++---
>  1 file changed, 5 insertions(+), 3 deletions(-)
> 
> diff --git a/drivers/tty/serial/samsung_tty.c 
> b/drivers/tty/serial/samsung_tty.c
> index 6ef614d8648c..b923683e6a25 100644
> --- a/drivers/tty/serial/samsung_tty.c
> +++ b/drivers/tty/serial/samsung_tty.c
> @@ -1911,9 +1911,11 @@ static int s3c24xx_serial_init_port(struct
> s3c24xx_uart_port *ourport,
>               ourport->tx_irq = ret + 1;
>       }
> 
> -     ret = platform_get_irq(platdev, 1);
> -     if (ret > 0)
> -             ourport->tx_irq = ret;
> +     if (!s3c24xx_serial_has_interrupt_mask(port)) {
> +             ret = platform_get_irq(platdev, 1);
> +             if (ret > 0)
> +                     ourport->tx_irq = ret;
> +     }
>       /*
>        * DMA is currently supported only on DT platforms, if DMA properties
>        * are specified.
> --
> 2.17.1



Reply via email to