> -----Messaggio originale-----
> Da: Christian Lamparter <[email protected]>
> Inviato: venerdì 18 settembre 2020 18:54
> A: Ansuel Smith <[email protected]>; Kalle Valo
> <[email protected]>
> Cc: [email protected]; [email protected]; linux-
> [email protected]; [email protected];
> [email protected]; David S. Miller <[email protected]>; Rob
> Herring <[email protected]>; Jakub Kicinski <[email protected]>; linux-
> [email protected]; Srinivas Kandagatla
> <[email protected]>; Bartosz Golaszewski
> <[email protected]>
> Oggetto: Re: [PATCH 2/2] dt: bindings: ath10k: Document qcom, ath10k-
> pre-calibration-data-mtd
>
> On 2020-09-18 18:29, Ansuel Smith wrote:
> > Document use of qcom,ath10k-pre-calibration-data-mtd bindings used to
> > define from where the driver will load the pre-cal data in the defined
> > mtd partition.
> >
> > Signed-off-by: Ansuel Smith <[email protected]>
>
> Q: Doesn't mtd now come with nvmem support from the get go? So
> the MAC-Addresses and pre-caldata could be specified as a
> nvmem-node in the devicetree? I remember seeing that this was
> worked on or was this mtd->nvmem dropped?
>
> Cheers,
> Christian
Sorry a lot for the double email... I think I found what you are talking about.
It looks like the code was merged but not the documentation.
Will do some test and check if this works.
This should be the related patch.
https://patchwork.ozlabs.org/project/linux-mtd/patch/[email protected]/
