Neil Armstrong <[email protected]> writes: > Hi Kevin, > > On 17/09/2020 08:59, Neil Armstrong wrote: >> The Amlogic AXG is close to the GXL Glue but with a single OTG PHY. >> >> It needs the same init sequence as GXL & GXM, but it seems it doesn't need >> the host disconnect bit. >> >> The Glue driver reuses the already implemented GXL & GXM work. >> >> The USB2 PHY driver needs a slight tweak to keep the OTG detection working. >> >> Changes since v1 at [1]: >> - s/close from/close to/g >> - collected review tags >> - added small comment about phy management in patch 3 >> - removed status = "okay" in patch 4 >> - removed invalid phy-supply of phy1 in patch 5 >> >> [1] http://lore.kernel.org/r/[email protected] >> >> Neil Armstrong (5): >> phy: amlogic: phy-meson-gxl-usb2: keep ID pull-up even in Host mode >> dt-bindings: usb: amlogic,meson-g12a-usb-ctrl: add the Amlogic AXG >> Families USB Glue Bindings >> usb: dwc-meson-g12a: Add support for USB on AXG SoCs >> arm64: dts: meson-axg: add USB nodes >> arm64: dts: meson-axg-s400: enable USB OTG > > Can you pick the DT patches ?
Yes, queued up. Since we're already at -rc7, this may not make it until v5.11. Kevin
