Linus Walleij writes:
> Hi Lars, > > a new version of the patch set arrives while I'm reviewing, haha :D Well, luckily not too much changed per Rob's input. > > On Wed, Oct 7, 2020 at 1:12 PM Lars Povlsen <[email protected]> > wrote: > >> This adds DT bindings for the Microsemi/Microchip SGPIO controller, >> bindings microchip,sparx5-sgpio, mscc,ocelot-sgpio and >> mscc,luton-sgpio. >> >> Signed-off-by: Lars Povlsen <[email protected]> > > (...) >> + reg: >> + description: | >> + The GPIO bank number. "0" is designates the input pin bank, >> + "1" the output bank. >> + maxItems: 1 > > Excellent. > >> + '#gpio-cells': >> + const: 3 > > So I thought you needed three cells exactly because the > middle cell would get you the bank. That you now have in > reg. So what about using the standard twocell? I think I answered that in the 'v3 2/3' reply. Basically the pins are addressed with two indices, and there are good reasons to expose these to the GPIO cells, f.ex. hardware documentation cross reference. ---Lars > > Yours, > Linus Walleij -- Lars Povlsen, Microchip
