Per the 802.3cg spec the 10base T1L can operate at 2 different
differential voltages 1v p2p and 2.4v p2p. The abiility of the PHY to
drive that output is dependent on the PHY's on board power supply.
This common feature is applicable to all 10base T1L PHYs so this binding
property belongs in a top level ethernet document.
Signed-off-by: Dan Murphy <dmur...@ti.com>
---
Documentation/devicetree/bindings/net/ethernet-phy.yaml | 5 +++++
1 file changed, 5 insertions(+)
diff --git a/Documentation/devicetree/bindings/net/ethernet-phy.yaml
b/Documentation/devicetree/bindings/net/ethernet-phy.yaml
index 6dd72faebd89..5cad653e143b 100644
--- a/Documentation/devicetree/bindings/net/ethernet-phy.yaml
+++ b/Documentation/devicetree/bindings/net/ethernet-phy.yaml
@@ -174,6 +174,11 @@ properties:
PHY's that have configurable TX internal delays. If this property is
present then the PHY applies the TX delay.
+ tx-rx-output-high:
+ type: boolean
+ description: |
+ Enable the 2.4v p2p differential output voltage for 10base-T1L PHYs.
+
required:
- reg
--
2.28.0.585.ge1cfff676549
