Hi Chris, Before a new property "enable-strobe-pulldown" is introduced in the code a change to the documents must be made in a separate patch. (rockchip-emmc-phy.txt)
./scripts/checkpatch.pl --strict <patch1> <patch2> On 11/27/20 4:33 AM, Chris Ruehl wrote: > This patch add support to set the internal pulldown via dt property > and allow simplify the board design for the trace from emmc-phy to > the eMMC chipset. > Default to not set the pull-down. > > This patch was inspired from the 4.4 tree of the > Rockchip SDK, where it is enabled unconditional. > The patch had been tested with our rk3399 customized board. > > Signed-off-by: Chris Ruehl <chris.ru...@gtsys.com.hk> > --- > drivers/phy/rockchip/phy-rockchip-emmc.c | 16 ++++++++++++++++ > 1 file changed, 16 insertions(+) > > diff --git a/drivers/phy/rockchip/phy-rockchip-emmc.c > b/drivers/phy/rockchip/phy-rockchip-emmc.c > index 2dc19ddd120f..d9bc45828f74 100644 > --- a/drivers/phy/rockchip/phy-rockchip-emmc.c > +++ b/drivers/phy/rockchip/phy-rockchip-emmc.c > @@ -67,6 +67,10 @@ > #define PHYCTRL_OTAPDLYENA_SHIFT 0xb > #define PHYCTRL_OTAPDLYSEL_MASK 0xf > #define PHYCTRL_OTAPDLYSEL_SHIFT 0x7 > +#define PHYCTRL_REN_STRB_DISABLE 0x0 > +#define PHYCTRL_REN_STRB_ENABLE 0x1 > +#define PHYCTRL_REN_STRB_MASK 0x1 > +#define PHYCTRL_REN_STRB_SHIFT 0x9 align with extra TAB ? check TAB size > > #define PHYCTRL_IS_CALDONE(x) \ > ((((x) >> PHYCTRL_CALDONE_SHIFT) & \ > @@ -80,6 +84,7 @@ struct rockchip_emmc_phy { > struct regmap *reg_base; > struct clk *emmcclk; > unsigned int drive_impedance; > + unsigned int enable_strobe_pulldown; > }; > > static int rockchip_emmc_phy_power(struct phy *phy, bool on_off) > @@ -295,6 +300,13 @@ static int rockchip_emmc_phy_power_on(struct phy *phy) > PHYCTRL_OTAPDLYSEL_MASK, > PHYCTRL_OTAPDLYSEL_SHIFT)); > > + /* Internal pull-down for strobe line */ > + regmap_write(rk_phy->reg_base, > + rk_phy->reg_offset + GRF_EMMCPHY_CON2, CHECK: Alignment should match open parenthesis #49: FILE: drivers/phy/rockchip/phy-rockchip-emmc.c:305: + regmap_write(rk_phy->reg_base, + rk_phy->reg_offset + GRF_EMMCPHY_CON2, > + HIWORD_UPDATE(rk_phy->enable_strobe_pulldown, > + PHYCTRL_REN_STRB_MASK, > + PHYCTRL_REN_STRB_SHIFT)); CHECK: Alignment should match open parenthesis #51: FILE: drivers/phy/rockchip/phy-rockchip-emmc.c:307: + HIWORD_UPDATE(rk_phy->enable_strobe_pulldown, + PHYCTRL_REN_STRB_MASK, > + > /* Power up emmc phy analog blocks */ > return rockchip_emmc_phy_power(phy, PHYCTRL_PDB_PWR_ON); > } > @@ -359,10 +371,14 @@ static int rockchip_emmc_phy_probe(struct > platform_device *pdev) > rk_phy->reg_offset = reg_offset; > rk_phy->reg_base = grf; > rk_phy->drive_impedance = PHYCTRL_DR_50OHM; > + rk_phy->enable_strobe_pulldown = PHYCTRL_REN_STRB_DISABLE; > > if (!of_property_read_u32(dev->of_node, "drive-impedance-ohm", &val)) > rk_phy->drive_impedance = convert_drive_impedance_ohm(pdev, > val); > > + if (of_property_read_bool(dev->of_node, "enable-strobe-pulldown")) > + rk_phy->enable_strobe_pulldown = PHYCTRL_REN_STRB_ENABLE; > + > generic_phy = devm_phy_create(dev, dev->of_node, &ops); > if (IS_ERR(generic_phy)) { > dev_err(dev, "failed to create PHY\n"); >