On Sun, Jan 10, 2021 at 7:12 PM Fabian Vogt <fab...@ritter-vogt.de> wrote: > Am Samstag, 9. Januar 2021, 23:20:48 CET schrieb Arnd Bergmann: > > On Sat, Jan 9, 2021 at 1:06 AM Daniel Tang <dt.ta...@gmail.com> wrote: > > > > > > Hi Arnd, > > > > > > On 9 Jan 2021, at 9:55 am, Arnd Bergmann <a...@kernel.org> wrote: > > > > > > * nspire -- added in 2013, no notable changes after 2015 > > Most of the platform is just the DT sources and some small drivers around it, > so it's actually fairly low maintenance. So far the migration away from > panel-simple in 2019 > (https://lore.kernel.org/linux-arm-kernel/20190805085847.25554-1-linus.wall...@linaro.org) > was the biggest required change so far.
Sure, there is no problem in keeping it around as long as it is used. There were a couple of platforms that had not seen a lot of changes in the past five years but that are still in active use, I just used it as an indication that I should ask about the status. A lot of the other platforms that list only ever had an incomplete port and were abandoned before they were fully supported in upstream kernels. > > Would either of you already have a guess for how long it makes > > sense to update kernels on it? > > > > I see that this is one of the more limited platforms with just 32MB > > of RAM (64MB in case of CX), and kernels only get more bloated over > > time, so I expect at some point you will be stuck with running old > > software. > > The kernel overhead isn't actually that bad. I just built today's 2ff90100ace8 > and booted it with a busybox-based initrd. free -m reports: > total used free shared buffers > 58 12 46 0 0 > > Relatively speaking, still mostly unused ;-) The stock OS actually uses more! > With 32MiB, the situation is definitely worse, but still manageable. Should > that change in the future, dropping just the Classic/CM variants would be a > possible option, but that still seems far enough away. Ok, makes sense. > > Wikipedia tells me that new models came out recently. Are you > > planning to add support for those as well? > > Yes, someone from the community actually managed to boot Linux on a CX II-T, > and I'm hoping to get that upstreamed soon. Most of the hardware changes are > supported by drivers already and so this is mainly just another device tree. Nice! Arnd