On Thu, Feb 04, 2021 at 05:51:25PM +0800, [email protected] wrote: > From: Mingchuang Qiao <[email protected]> > > In bus scan flow, the "LTR Mechanism Enable" bit of DEVCTL2 register is > configured in pci_configure_ltr(). If device and bridge both support LTR > mechanism, the "LTR Mechanism Enable" bit of device and bridge will be > enabled in DEVCTL2 register. And pci_dev->ltr_path will be set as 1. > > If PCIe link goes down when device resets, the "LTR Mechanism Enable" bit > of bridge will change to 0 according to PCIe r5.0, sec 7.5.3.16. However, > the pci_dev->ltr_path value of bridge is still 1. > > For following conditions, check and re-configure "LTR Mechanism Enable" bit > of bridge to make "LTR Mechanism Enable" bit match ltr_path value. > -before configuring device's LTR for hot-remove/hot-add > -before restoring device's DEVCTL2 register when restore device state > > Signed-off-by: Mingchuang Qiao <[email protected]>
Reviewed-by: Mika Westerberg <[email protected]>
