Hello Dan,
> Von: Jacek Anaszewski <jacek.anaszew...@gmail.com>
> Gesendet: Freitag, 5. Februar 2021 19:37
> Hi Pavel,
>
> On 2/5/21 11:23 AM, Pavel Machek wrote:
> > Hi!
> >
> >>>> patternProperties:
> >>>> "(^led-[0-9a-f]$|led)":
> >>>> @@ -99,6 +104,7 @@ examples:
> >>>> reg = <0x1>;
> >>>> color = <LED_COLOR_ID_RGB>;
> >>>> function = LED_FUNCTION_CHARGING;
> >>>> + default-intensity = <100 0 0>;
>
> How will you know which array position is for which child LED?
> I presume DT child nodes are not guaranteed to be parsed in the order
> of declaration?
I tried to fiddle this out, but it seems Jacek is right over here.
The multi-led definition looks like this (from the documentation
leds-lp50xx.yaml)
multi-led@1 {
#address-cells = <1>;
#size-cells = <0>;
reg = <0x1>;
color = <LED_COLOR_ID_RGB>;
function = LED_FUNCTION_CHARGING;
led-0 {
color = <LED_COLOR_ID_RED>;
};
led-1 {
color = <LED_COLOR_ID_GREEN>;
};
led-2 {
color = <LED_COLOR_ID_BLUE>;
};
};
But it seems that the color definition of each led is ignored.
By ignored I mean the driver does not take care which color
is at which position. So if I change led-0 to be LED_COLOR_ID_BLUE
and led-2 to be LED_COLOR_ID_RED nothing will change if I write
from userspace. Could you help to clarify?
Then it is even hard to know which led to set with default-intensity.
Also it seems that the enumeration of the multi-leds should
start with multi-led@0 (and not 1 as in the documentation).
Best Regards,
Sven
