On 3/4/2021 5:08 PM, Vladimir Oltean wrote: > On Tue, Mar 02, 2021 at 07:37:34PM -0800, Florian Fainelli wrote: >> Took a while but for the 54210E reference board here are the numbers, >> your mileage will vary depending on the supplies, regulator efficiency >> and PCB design around the PHY obviously: >> >> BMCR.PDOWN: 86.12 mW >> auto-power down: 77.84 mW > > Quite curious that the APD power is lower than the normal BMCR.PDOWN > value. As far as my understanding goes, when in APD mode, the PHY even > wakes up from time to time to send pulses to the link partner? Auto-power down kicks in when the cable is disconnected. There is another IDDQ mode that supports energy detection though I am unsure of when it would be useful for most Linux enabled systems. > >> auto-power-down, DLL disabled: 30.83 mW > > The jump from simple APD to APD with DLL disabled is pretty big. > Correct me if I'm wrong, but there's an intermediary step which was not > measured, where the CLK125 is disabled but the internal DLL (Delay > Locked Loop?) is still enabled. I think powering off the internal DLL > also implies powering off the CLK125 pin, at least that's how the PHY > driver treats things at the moment. But we don't know if the huge > reduction in power is due just to CLK125 or the DLL (it's more likely > it's due to both, in equal amounts). Agree, I do not have the break down though. > > Anyway, it's great to have some results which tell us exactly what is > worthwhile and what isn't. In other news, I've added the BCM5464 to the > list of PHYs with APD and I didn't see any issues thus far. > >> IDDQ-low power: 9.85 mW (requires a RESETn toggle) >> IDDQ with soft recovery: 10.75 mW >> >> Interestingly, the 50212E that I am using requires writing the PDOWN bit >> and only that bit (not a RMW) in order to get in a correct state, both >> LEDs keep flashing when that happens, fixes coming. >> >> When net-next opens back up I will submit patches to support IDDQ with >> soft recovery since that is clearly much better than the standard power >> down and it does not require a RESETn toggle. > > Iddq must be the quiescent supply current, isn't it (but in that case, > I'm a bit confused to not see a value in mA)? Is it an actual operating > mode (I don't see anything about that mentioned in the BCM5464 sheet) > and if it is, what is there exactly to support? You would put the PHY in IDDQ with soft recovery (or ultra low power) when you are administratively bringing down the network interface (and its PHY), or when suspending to a low power state where Wake-on-LAN is not enabled. -- Florian
