Hi Jacopo, s/dealy/delay/ in $SUBJECT
On 19/03/2021 16:41, Jacopo Mondi wrote: > Add a delay after the OV490 chip is put in reset state. The reset > signal shall be held for at least 250 useconds. > > Signed-off-by: Jacopo Mondi <jacopo+rene...@jmondi.org> > --- > drivers/media/i2c/rdacm21.c | 6 +++++- > 1 file changed, 5 insertions(+), 1 deletion(-) > > diff --git a/drivers/media/i2c/rdacm21.c b/drivers/media/i2c/rdacm21.c > index babd14b21252..875bec9f7904 100644 > --- a/drivers/media/i2c/rdacm21.c > +++ b/drivers/media/i2c/rdacm21.c > @@ -448,7 +448,10 @@ static int rdacm21_init(struct v4l2_subdev *sd, unsigned > int val) > if (ret) > return ret; > > - /* Enable GPIO1 and hold OV490 in reset during max9271 configuration. */ > + /* > + * Enable GPIO1 and hold OV490 in reset during max9271 configuration. > + * The reset signal has to be asserted for at least 250 useconds. > + */ > ret = max9271_enable_gpios(&dev->serializer, MAX9271_GPIO1OUT); > if (ret) > return ret; > @@ -456,6 +459,7 @@ static int rdacm21_init(struct v4l2_subdev *sd, unsigned > int val) > ret = max9271_clear_gpios(&dev->serializer, MAX9271_GPIO1OUT); > if (ret) > return ret; > + usleep_range(250, 500); Aha, for a second there I thought the comment meant it had to be asserted for 250 uS before clearing it again. But it's 250 uS before using the OV490. Perhaps possible to update the comment a little, but nothing that matters. Reviewed-by: Kieran Bingham <kieran.bingham+rene...@ideasonboard.com> > ret = max9271_configure_gmsl_link(&dev->serializer); > if (ret) >
