Changeset 5513b411ea5b ("Documentation: rename pinctl to pin-control")
renamed: Documentation/driver-api/pinctl.rst
to: Documentation/driver-api/pin-control.rst.

Update the cross-references accordingly.

Fixes: 5513b411ea5b ("Documentation: rename pinctl to pin-control")
Signed-off-by: Mauro Carvalho Chehab <mchehab+hua...@kernel.org>
---
 include/linux/device.h                  | 2 +-
 include/linux/mfd/madera/pdata.h        | 2 +-
 include/linux/pinctrl/pinconf-generic.h | 2 +-
 3 files changed, 3 insertions(+), 3 deletions(-)

diff --git a/include/linux/device.h b/include/linux/device.h
index 38a2071cf776..d1183cfdc8fb 100644
--- a/include/linux/device.h
+++ b/include/linux/device.h
@@ -399,7 +399,7 @@ struct dev_links_info {
  *             along with subsystem-level and driver-level callbacks.
  * @em_pd:     device's energy model performance domain
  * @pins:      For device pin management.
- *             See Documentation/driver-api/pinctl.rst for details.
+ *             See Documentation/driver-api/pin-control.rst for details.
  * @msi_list:  Hosts MSI descriptors
  * @msi_domain: The generic MSI domain this device is using.
  * @numa_node: NUMA node this device is close to.
diff --git a/include/linux/mfd/madera/pdata.h b/include/linux/mfd/madera/pdata.h
index 601cbbc10370..32e3470708ed 100644
--- a/include/linux/mfd/madera/pdata.h
+++ b/include/linux/mfd/madera/pdata.h
@@ -31,7 +31,7 @@ struct pinctrl_map;
  * @irq_flags:     Mode for primary IRQ (defaults to active low)
  * @gpio_base:     Base GPIO number
  * @gpio_configs:   Array of GPIO configurations (See
- *                 Documentation/driver-api/pinctl.rst)
+ *                 Documentation/driver-api/pin-control.rst)
  * @n_gpio_configs: Number of entries in gpio_configs
  * @gpsw:          General purpose switch mode setting. Depends on the external
  *                 hardware connected to the switch. (See the SW1_MODE field
diff --git a/include/linux/pinctrl/pinconf-generic.h 
b/include/linux/pinctrl/pinconf-generic.h
index 6aeb711f7cd1..fdcd773adba3 100644
--- a/include/linux/pinctrl/pinconf-generic.h
+++ b/include/linux/pinctrl/pinconf-generic.h
@@ -88,7 +88,7 @@ struct pinctrl_map;
  *     it.
  * @PIN_CONFIG_OUTPUT: this will configure the pin as an output and drive a
  *     value on the line. Use argument 1 to indicate high level, argument 0 to
- *     indicate low level. (Please see Documentation/driver-api/pinctl.rst,
+ *     indicate low level. (Please see 
Documentation/driver-api/pin-control.rst,
  *     section "GPIO mode pitfalls" for a discussion around this parameter.)
  * @PIN_CONFIG_POWER_SOURCE: if the pin can select between different power
  *     supplies, the argument to this parameter (on a custom format) tells
-- 
2.30.2

Reply via email to