On 11/16/2012 05:57 PM, Marcelo Tosatti wrote:
> On Fri, Nov 16, 2012 at 12:46:16PM +0800, Xiao Guangrong wrote:
>> On 11/16/2012 11:56 AM, Marcelo Tosatti wrote:
>>> On Fri, Nov 16, 2012 at 11:39:12AM +0800, Xiao Guangrong wrote:
>>>> On 11/16/2012 11:02 AM, Marcelo Tosatti wrote:
>>>>> On Thu, Nov 15, 2012 at 07:17:15AM +0800, Xiao Guangrong wrote:
>>>>>> On 11/14/2012 10:37 PM, Marcelo Tosatti wrote:
>>>>>>> On Tue, Nov 13, 2012 at 04:26:16PM +0800, Xiao Guangrong wrote:
>>>>>>>> Hi Marcelo,
>>>>>>>>
>>>>>>>> On 11/13/2012 07:10 AM, Marcelo Tosatti wrote:
>>>>>>>>> On Mon, Nov 05, 2012 at 05:59:26PM +0800, Xiao Guangrong wrote:
>>>>>>>>>> Do not drop large spte until it can be insteaded by small pages so
>>>>>>>>>> that
>>>>>>>>>> the guest can happliy read memory through it
>>>>>>>>>>
>>>>>>>>>> The idea is from Avi:
>>>>>>>>>> | As I mentioned before, write-protecting a large spte is a good
>>>>>>>>>> idea,
>>>>>>>>>> | since it moves some work from protect-time to fault-time, so it
>>>>>>>>>> reduces
>>>>>>>>>> | jitter. This removes the need for the return value.
>>>>>>>>>>
>>>>>>>>>> Signed-off-by: Xiao Guangrong <xiaoguangr...@linux.vnet.ibm.com>
>>>>>>>>>> ---
>>>>>>>>>> arch/x86/kvm/mmu.c | 34 +++++++++-------------------------
>>>>>>>>>> 1 files changed, 9 insertions(+), 25 deletions(-)
>>>>>>>>>
>>>>>>>>> Its likely that other 4k pages are mapped read-write in the 2mb range
>>>>>>>>> covered by a read-only 2mb map. Therefore its not entirely useful to
>>>>>>>>> map read-only.
>>>>>>>>>
>>>>>>>>
>>>>>>>> It needs a page fault to install a pte even if it is the read access.
>>>>>>>> After the change, the page fault can be avoided.
>>>>>>>>
>>>>>>>>> Can you measure an improvement with this change?
>>>>>>>>
>>>>>>>> I have a test case to measure the read time which has been attached.
>>>>>>>> It maps 4k pages at first (dirt-loggged), then switch to large sptes
>>>>>>>> (stop dirt-logging), at the last, measure the read access time after
>>>>>>>> write
>>>>>>>> protect sptes.
>>>>>>>>
>>>>>>>> Before: 23314111 ns After: 11404197 ns
>>>>>>>
>>>>>>> Ok, i'm concerned about cases similar to e49146dce8c3dc6f44 (with
>>>>>>> shadow),
>>>>>>> that is:
>>>>>>>
>>>>>>> - large page must be destroyed when write protecting due to
>>>>>>> shadowed page.
>>>>>>> - with shadow, it does not make sense to write protect
>>>>>>> large sptes as mentioned earlier.
>>>>>>>
>>>>>>
>>>>>> This case is removed now, the code when e49146dce8c3dc6f44 was applied
>>>>>> is:
>>>>>> |
>>>>>> | pt = sp->spt;
>>>>>> | for (i = 0; i < PT64_ENT_PER_PAGE; ++i)
>>>>>> | /* avoid RMW */
>>>>>> | if (is_writable_pte(pt[i]))
>>>>>> | update_spte(&pt[i], pt[i] &
>>>>>> ~PT_WRITABLE_MASK);
>>>>>> | }
>>>>>>
>>>>>> The real problem in this code is it would write-protect the spte even if
>>>>>> it is not a last spte that caused the middle-level shadow page table was
>>>>>> write-protected. So e49146dce8c3dc6f44 added this code:
>>>>>> | if (sp->role.level != PT_PAGE_TABLE_LEVEL)
>>>>>> | continue;
>>>>>> |
>>>>>> was good to fix this problem.
>>>>>>
>>>>>> Now, the current code is:
>>>>>> | for (i = 0; i < PT64_ENT_PER_PAGE; ++i) {
>>>>>> | if (!is_shadow_present_pte(pt[i]) ||
>>>>>> | !is_last_spte(pt[i], sp->role.level))
>>>>>> | continue;
>>>>>> |
>>>>>> | spte_write_protect(kvm, &pt[i], &flush, false);
>>>>>> | }
>>>>>> It only write-protect the last spte. So, it allows large spte existent.
>>>>>> (the large spte can be broken by drop_large_spte() on the page-fault
>>>>>> path.)
>>>>>>
>>>>>>> So i wonder why is this part from your patch
>>>>>>>
>>>>>>> - if (level > PT_PAGE_TABLE_LEVEL &&
>>>>>>> - has_wrprotected_page(vcpu->kvm, gfn, level)) {
>>>>>>> - ret = 1;
>>>>>>> - drop_spte(vcpu->kvm, sptep);
>>>>>>> - goto done;
>>>>>>> - }
>>>>>>>
>>>>>>> necessary (assuming EPT is in use).
>>>>>>
>>>>>> This is safe, we change these code to:
>>>>>>
>>>>>> - if (mmu_need_write_protect(vcpu, gfn, can_unsync)) {
>>>>>> + if ((level > PT_PAGE_TABLE_LEVEL &&
>>>>>> + has_wrprotected_page(vcpu->kvm, gfn, level)) ||
>>>>>> + mmu_need_write_protect(vcpu, gfn, can_unsync)) {
>>>>>> pgprintk("%s: found shadow page for %llx,
>>>>>> marking ro\n",
>>>>>> __func__, gfn);
>>>>>> ret = 1;
>>>>>>
>>>>>> The spte become read-only which can ensure the shadow gfn can not be
>>>>>> changed.
>>>>>>
>>>>>> Btw, the origin code allows to create readonly spte under this case if
>>>>>> !(pte_access & WRITEABBLE)
>>>>>
>>>>> Regarding shadow: it should be fine as long as fault path always deletes
>>>>> large mappings, when shadowed pages are present in the region.
>>>>
>>>> For hard mmu is also safe, in this patch i added these code:
>>>>
>>>> @@ -2635,6 +2617,8 @@ static int __direct_map(struct kvm_vcpu *vcpu, gpa_t
>>>> v, int write,
>>>> break;
>>>> }
>>>>
>>>> + drop_large_spte(vcpu, iterator.sptep);
>>>> +
>>>>
>>>> It can delete large mappings like soft mmu does.
>>>>
>>>> Anything i missed?
>>>>
>>>>>
>>>>> Ah, unshadowing from reexecute_instruction does not handle
>>>>> large pages. I suppose that is what "simplification" refers
>>>>> to.
>>>>
>>>> reexecute_instruction did not directly handle last spte, it just
>>>> removes all shadow pages, then let cpu retry the instruction, the
>>>> page can become writable when encounter #PF again, large spte is fine
>>>> under this case.
>>>
>>> While searching for a given "gpa", you don't find large gfn which is
>>> mapping it, right? (that is, searching for gfn 4 fails to find large
>>> read-only "gfn 0"). Unshadowing gfn 4 will keep large read-only mapping
>>> present.
>>>
>>> 1. large read-write spte to gfn 0
>>> 2. shadow gfn 4
>>> 3. write-protect large spte pointing to gfn 0
>>> 4. write to gfn 4
>>> 5. instruction emulation fails
>>> 5. unshadow gfn 4
>>> 6. refault, do not drop large spte because no pages shadowed
> 7. refault, then goto 2 (as part of write to gfn 4)
>>
>> Hmm, it is not true. :)
>>
>> The large spte can become writable since 'no pages adhadoes' (that means
>> has_wrprotected_page() can return 0 for this case). No?
>
> What if gfn 4 is a pagetable part of the pagedirectory chain used to
> map gfn 4? See corrected step 7 above.
Ah, this is a real bug, and unfortunately, it exists in current
code. I will make a separate patchset to fix it. Thank you, Marcelo!
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
