The intent here was to test if the bit was set or not but there is a
logical vs bitwise AND typo so it is true if any bits are set.

Signed-off-by: Dan Carpenter <[email protected]>
---
I can't compile this.

diff --git a/drivers/pinctrl/pinctrl-abx500.c b/drivers/pinctrl/pinctrl-abx500.c
index 1d3f988..9afae3f 100644
--- a/drivers/pinctrl/pinctrl-abx500.c
+++ b/drivers/pinctrl/pinctrl-abx500.c
@@ -426,7 +426,7 @@ static int abx500_set_mode(struct pinctrl_dev *pctldev, 
struct gpio_chip *chip,
                                ret = abx500_gpio_set_bits(chip,
                                        AB8500_GPIO_ALTFUN_REG,
                                        af.alt_bit2,
-                                       !!(af.alta_val && BIT(1)));
+                                       !!(af.alta_val & BIT(1)));
                } else
                        ret = abx500_gpio_set_bits(chip, AB8500_GPIO_SEL1_REG,
                                        offset, 1);
@@ -447,7 +447,7 @@ static int abx500_set_mode(struct pinctrl_dev *pctldev, 
struct gpio_chip *chip,
                        ret = abx500_gpio_set_bits(chip,
                                        AB8500_GPIO_ALTFUN_REG,
                                        af.alt_bit2,
-                                       !!(af.altb_val && BIT(1)));
+                                       !!(af.altb_val & BIT(1)));
                break;
 
        case ABX500_ALT_C:
@@ -457,7 +457,7 @@ static int abx500_set_mode(struct pinctrl_dev *pctldev, 
struct gpio_chip *chip,
                        goto out;
 
                ret = abx500_gpio_set_bits(chip, AB8500_GPIO_ALTFUN_REG,
-                               af.alt_bit2, !!(af.altc_val && BIT(0)));
+                               af.alt_bit2, !!(af.altc_val & BIT(0)));
                if (ret < 0)
                        goto out;
 
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [email protected]
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/

Reply via email to