> -----Original Message-----
> From: Vinod Koul [mailto:vinod.k...@intel.com]
> Sent: Tuesday, September 03, 2013 7:32 PM
> To: Lu Jingchang-B35083
> Cc: shawn....@linaro.org; linux-kernel@vger.kernel.org; linux-arm-
> ker...@lists.infradead.org; devicet...@vger.kernel.org
> Subject: Re: [PATCH v4 3/3] dma: Add Freescale eDMA engine driver support
>
> On Tue, Sep 03, 2013 at 05:43:21AM +0000, Lu Jingchang-B35083 wrote:
> > Do you mean the DMA_SLAVE_CONFIG device_control? Yeah, the slave
> driver could pass
> > the slave_id. But the DMA_SLAVE_CONFIG may be called more than once,
> and the eDMA
> > driver just needs to set the slave id once for any given channel, after
> that the
> > transfer is transparent to the device.
> It depends, for a channel requested, if you are only tranferring to a
> particular
> slave device then it can be confugured once.
> so
> 1. allocate channel
> 2. dmaengine_slave_config()
>
> then you cnan do preare etc multiple times based on need.
But if the preferred slave id configuration should be in
dmaengine_slave_config,
I will send out this change in the next version patch.
Thanks!
Best Regards,
Jingchang
N�����r��y����b�X��ǧv�^�){.n�+����{����zX����ܨ}���Ơz�&j:+v�������zZ+��+zf���h���~����i���z� �w���?�����&�)ߢf��^jǫy�m��@A�a���
0��h���i
