From: Austin Beam <austinb...@ti.com>
Enable the dra7x errata workaround for false disconnect problem
with USB2PHY. False disconnects were detected with some of the devices.
Reduce the sensitivity of the disconnect logic within the USB2PHY subsystem
to enusre these false disconnects are not registered.
[george.cher...@ti.com]
While at that, pass proper flags for each SoC's. This is a common driver
used across OMAP4,OMAP5,DRA7xx and AM437x USB2PHY.
False disconnect workaround is currently applicable for only DRA7x.
Update the Documentation also to add new comaptible.
Signed-off-by: Austin Beam <austinb...@ti.com>
Signed-off-by: George Cherian <george.cher...@ti.com>
Signed-off-by: Kishon Vijay Abraham I <kis...@ti.com>
---
Documentation/devicetree/bindings/usb/usb-phy.txt | 3 +-
drivers/phy/phy-omap-usb2.c | 48 +++++++++++++++++++++++
include/linux/usb/omap_usb.h | 3 ++
3 files changed, 53 insertions(+), 1 deletion(-)
diff --git a/Documentation/devicetree/bindings/usb/usb-phy.txt
b/Documentation/devicetree/bindings/usb/usb-phy.txt
index b3fa409..03de61a5 100644
--- a/Documentation/devicetree/bindings/usb/usb-phy.txt
+++ b/Documentation/devicetree/bindings/usb/usb-phy.txt
@@ -4,7 +4,8 @@ OMAP USB2 PHY
Required properties:
- compatible: Should be either of
- * "ti,omap-usb2" for OMAP4, OMAP5, DRA7
+ * "ti,omap-usb2" for OMAP4 and OMAP5
+ * "ti,dra7x-usb2" for DRA7
* "ti,am437x-usb2" for AM437x
- reg : Address and length of the register set for the device.
- #phy-cells: determine the number of cells that should be given in the
diff --git a/drivers/phy/phy-omap-usb2.c b/drivers/phy/phy-omap-usb2.c
index d54f24b..80ba7f0 100644
--- a/drivers/phy/phy-omap-usb2.c
+++ b/drivers/phy/phy-omap-usb2.c
@@ -31,6 +31,9 @@
#include <linux/phy/phy.h>
#include <linux/of_platform.h>
+#define USB2PHY_DISCON_BYP_LATCH (1 << 31)
+#define USB2PHY_ANA_CONFIG1 0x4c
+
/**
* omap_usb2_set_comparator - links the comparator present in the sytem with
* this phy
@@ -138,7 +141,30 @@ static int omap_usb_power_on(struct phy *x)
return 0;
}
+static int omap_usb_init(struct phy *x)
+{
+ struct omap_usb *phy = phy_get_drvdata(x);
+ u32 val;
+
+ if (phy->flags & OMAP_USB2_CALIBRATE_FALSE_DISCONNECT) {
+ /*
+ *
+ * Reduce the sensitivity of internal PHY by enabling the
+ * DISCON_BYP_LATCH of the USB2PHY_ANA_CONFIG1 register. This
+ * resolves issues with certain devices which can otherwise
+ * be prone to false disconnects.
+ *
+ */
+ val = omap_usb_readl(phy->phy_base, USB2PHY_ANA_CONFIG1);
+ val |= USB2PHY_DISCON_BYP_LATCH;
+ omap_usb_writel(phy->phy_base, USB2PHY_ANA_CONFIG1, val);
+ }
+
+ return 0;
+}
+
static struct phy_ops ops = {
+ .init = omap_usb_init,
.power_on = omap_usb_power_on,
.power_off = omap_usb_power_off,
.owner = THIS_MODULE,
@@ -150,6 +176,11 @@ static const struct usb_phy_data omap_usb2_data = {
.flags = OMAP_USB2_HAS_START_SRP | OMAP_USB2_HAS_SET_VBUS,
};
+static const struct usb_phy_data dra7x_usb2_data = {
+ .label = "dra7x_usb2",
+ .flags = OMAP_USB2_CALIBRATE_FALSE_DISCONNECT,
+};
+
static const struct usb_phy_data am437x_usb2_data = {
.label = "am437x_usb2",
.flags = 0,
@@ -161,6 +192,10 @@ static const struct of_device_id omap_usb2_id_table[] = {
.data = &omap_usb2_data,
},
{
+ .compatible = "ti,dra7x-usb2",
+ .data = &dra7x_usb2_data,
+ },
+ {
.compatible = "ti,am437x-usb2",
.data = &am437x_usb2_data,
},
@@ -173,6 +208,7 @@ static int omap_usb2_probe(struct platform_device *pdev)
{
struct omap_usb *phy;
struct phy *generic_phy;
+ struct resource *res;
struct phy_provider *phy_provider;
struct usb_otg *otg;
struct device_node *node = pdev->dev.of_node;
@@ -208,6 +244,18 @@ static int omap_usb2_probe(struct platform_device *pdev)
phy->phy.otg = otg;
phy->phy.type = USB_PHY_TYPE_USB2;
+ if (phy_data->flags & OMAP_USB2_CALIBRATE_FALSE_DISCONNECT) {
+ res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
+ if (!res) {
+ dev_err(&pdev->dev, "memory resource not available\n");
+ return -ENODEV;
+ }
+ phy->phy_base = devm_request_and_ioremap(&pdev->dev, res);
+ if (!phy->phy_base)
+ return -ENOMEM;
+ phy->flags |= OMAP_USB2_CALIBRATE_FALSE_DISCONNECT;
+ }
+
control_node = of_parse_phandle(node, "ctrl-module", 0);
if (!control_node) {
dev_err(&pdev->dev, "Failed to get control device phandle\n");
diff --git a/include/linux/usb/omap_usb.h b/include/linux/usb/omap_usb.h
index 034161d..248a603 100644
--- a/include/linux/usb/omap_usb.h
+++ b/include/linux/usb/omap_usb.h
@@ -34,11 +34,13 @@ struct omap_usb {
struct usb_phy phy;
struct phy_companion *comparator;
void __iomem *pll_ctrl_base;
+ void __iomem *phy_base;
struct device *dev;
struct device *control_dev;
struct clk *wkupclk;
struct clk *sys_clk;
struct clk *optclk;
+ u8 flags;
u8 is_suspended:1;
};
@@ -50,6 +52,7 @@ struct usb_phy_data {
/* Driver Flags */
#define OMAP_USB2_HAS_START_SRP (1 << 0)
#define OMAP_USB2_HAS_SET_VBUS (1 << 1)
+#define OMAP_USB2_CALIBRATE_FALSE_DISCONNECT (1 << 2)
#define phy_to_omapusb(x) container_of((x), struct omap_usb, phy)
--
1.8.3.1
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
