* Robert Nelson <robertcnel...@gmail.com> [140512 13:27]: > >> > > >> > If these pins are not used for i2c2 on some capes, this device > >> > should be set to status = "disabled" state by default. Then > >> > u-boot could re-enable it on the boards that have i2c2 in use. > >> > >> To-date, this is the i2c bus that all capes have placed an at24 eeprom > >> for cape identification. > > > > And how many capes actually implement the eeprom cape identification > > out of the available capes? :) > > Not including one off designs in someone's lab. We will never have an > accurate number. ;) > > So far; just the ones that want their "cape" detected in the default > image currently being shipped by CircuitCo. Otherwise the few that > I've seen without an eeprom, usually follow this default pinmux. > > http://elinux.org/CircuitCo:Basic_Proto_Cape > > Which includes that i2c bus enabled.
OK thanks for the info. > Either case if fine with me. As who knows when the dtc "overlay" will > every truly make it mainline, as the capemgr was the only real kernel > user of the i2c/at24 eeprom information. Sounds like we should keep it disabled though so u-boot can be used to toggle it while waiting for the capemgr. That's because the board has a header for pins, so it's not exactly limited to just the capes. Anybody working on enabling/disabling cape dtb configurations in u-boot? Regards, Tony -- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
