wait_for_completion_timeout() returns unsigned long not int so the check
for <= should be == and the type unsigned long. With that fixup the return
value of flctl_dma_fifo0_transfer can be changed to 0 for success. This
changes the failure return value for wait_for_completion_timeout to
-ETIMEDOUT and implicitly 0 on success by initializing ret to 0.
The call-sites are fixed up to check for == 0 rather than > 0 as well.

Signed-off-by: Nicholas Mc Guire <hof...@osadl.org>
---

V2: As suggested by Laurent Pinchart <laurent.pinch...@ideasonboard.com>
    the expected success return value is 0 so rather than just fixing up
    wait_for_completion_timeout return handling the return value of
    flctl_dma_fifo0_transfer should be adjusted.

call sites:
read_fiforeg,write_ec_fiforeg assume > 0 == success
are fixed up to check for == 0 for success
and the comment in flctl_dma_fifo0_transfe 
        /* ret > 0 is success */
        return ret;
is dropped since returning 0 on success is the expected.

Patch was compile tested with ap325rxa_defconfig (implies
CONFIG_MTD_NAND_SH_FLCTL=y)

Patch is against 4.1-rc1 (localversion-next is -next-20150501)

 drivers/mtd/nand/sh_flctl.c |   13 +++++++------
 1 file changed, 7 insertions(+), 6 deletions(-)

diff --git a/drivers/mtd/nand/sh_flctl.c b/drivers/mtd/nand/sh_flctl.c
index c3ce81c..9b032dd 100644
--- a/drivers/mtd/nand/sh_flctl.c
+++ b/drivers/mtd/nand/sh_flctl.c
@@ -353,7 +353,8 @@ static int flctl_dma_fifo0_transfer(struct sh_flctl *flctl, 
unsigned long *buf,
        dma_addr_t dma_addr;
        dma_cookie_t cookie = -EINVAL;
        uint32_t reg;
-       int ret;
+       int ret = 0;
+       unsigned long time_left;
 
        if (dir == DMA_FROM_DEVICE) {
                chan = flctl->chan_fifo0_rx;
@@ -388,13 +389,14 @@ static int flctl_dma_fifo0_transfer(struct sh_flctl 
*flctl, unsigned long *buf,
                goto out;
        }
 
-       ret =
+       time_left =
        wait_for_completion_timeout(&flctl->dma_complete,
                                msecs_to_jiffies(3000));
 
-       if (ret <= 0) {
+       if (time_left == 0) {
                dmaengine_terminate_all(chan);
                dev_err(&flctl->pdev->dev, "wait_for_completion_timeout\n");
+               ret = -ETIMEDOUT;
        }
 
 out:
@@ -404,7 +406,6 @@ out:
 
        dma_unmap_single(chan->device->dev, dma_addr, len, dir);
 
-       /* ret > 0 is success */
        return ret;
 }
 
@@ -428,7 +429,7 @@ static void read_fiforeg(struct sh_flctl *flctl, int rlen, 
int offset)
 
        /* initiate DMA transfer */
        if (flctl->chan_fifo0_rx && rlen >= 32 &&
-               flctl_dma_fifo0_transfer(flctl, buf, rlen, DMA_DEV_TO_MEM) > 0)
+               flctl_dma_fifo0_transfer(flctl, buf, rlen, DMA_DEV_TO_MEM) == 0)
                        goto convert;   /* DMA success */
 
        /* do polling transfer */
@@ -487,7 +488,7 @@ static void write_ec_fiforeg(struct sh_flctl *flctl, int 
rlen,
 
        /* initiate DMA transfer */
        if (flctl->chan_fifo0_tx && rlen >= 32 &&
-               flctl_dma_fifo0_transfer(flctl, buf, rlen, DMA_MEM_TO_DEV) > 0)
+               flctl_dma_fifo0_transfer(flctl, buf, rlen, DMA_MEM_TO_DEV) == 0)
                        return; /* DMA success */
 
        /* do polling transfer */
-- 
1.7.10.4

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majord...@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/

Reply via email to