I have the following issue. I am trying to get an ATI Rage XL chip working on a MIPS-based processor, with a 2.6.11-based kernel from linux-mips.org. Now, I know that this was working with a 2.4.25-based kernel previously.
I seem to get intermittent strange issues, such as the machine freezing from time to time, but in general I get the following in my dmesg when I load the atyfb module: atyfb: using auxiliary register aperture atyfb: 3D RAGE XL (Mach64 GR, PCI-33MHz) [0x4752 rev 0x27] atyfb(aty_valid_pll_ct): pllvclk=50 MHz, vclk=25 MHz atyfb(aty_dsp_gt): dsp_config 0x307c0001, dsp_on_off 0x14fffff0 < Sometimes it will hang here > atyfb: 512K RESV, 29.498928 MHz XTAL, 230 MHz PLL, 83 Mhz MCLK, 63 MHz XCLK atyfb: Unsupported xclk source: 7. < Followed by a number of > atyfb: vclk out of range < and > atyfb: not enough video RAM < Finally I get > atyfb: can't set default video mode atyfb(aty_set_pll_ct): about to program: pll_ext_cntl=0x0f pll_gen_cntl=0xff pll_vclk_cntl=0xad atyfb(aty_set_pll_ct): setting clock 3 for FeedBackDivider 255, ReferenceDivider 255, PostDivider 3(0) < Other times it will hang here > And that's all I get. I'm assuming that most of my issues are due to the "Unsupported xclk source" message. Any ideas what I can do about this, or where I can go to learn more about how to make this thing work? -- Jim Ramsay "Me fail English? That's unpossible!" - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [EMAIL PROTECTED] More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/