On Tue, 28 Jul 2015, Dmitry Torokhov wrote: > On Tue, Jul 28, 2015 at 09:40:19AM +0100, Lee Jones wrote: > > On Mon, 27 Jul 2015, Dmitry Torokhov wrote: > > > > > On Mon, Jul 27, 2015 at 03:43:00PM -0700, Dmitry Torokhov wrote: > > > > On Thu, Jul 23, 2015 at 05:17:41PM +0100, S Twiss wrote: > > > > > From: S Twiss <stwiss.opensou...@diasemi.com> > > > > > > > > > > Add device tree bindings for the DA9062 OnKey driver component > > > > > > > > > > Signed-off-by: Steve Twiss <stwiss.opensou...@diasemi.com> > > > > > > > > > > --- > > > > > Changes in V3: > > > > > - Child driver specifics separated out into separate document > > > > > in this case ../input/da9062-onkey.txt > > > > > Changes in V2: > > > > > - No change > > > > > > > > > > This patch applies against linux-next and next-20150708 > > > > > > > > > > > > > > > .../devicetree/bindings/input/da9062-onkey.txt | 36 > > > > > ++++++++++++++++++++++ > > > > > Documentation/devicetree/bindings/mfd/da9062.txt | 3 ++ > > > > > > > > I dropped bits for mfd/da9062.txt, changed to mention both 9062 and > > > > 9063, folded into the onkey patch and applied. > > > > > > Argh, da9062 core is not in mainline yet... OK, below is the patch I > > > had; if Lee does not pick it up I'll re-apply it when da9062 core hits > > > mainline. > > > > Hmm... that's annoying. You've put the patch below your signature > > '--', so my mailer cuts it off. > > OK, sorry, I'll make sure to put in before the signature next time.
Appreciated. > > [pasting] > > > > > Input: add DA9062 OnKey capability to DA9063 OnKey driver > > > > > > From: S Twiss <stwiss.opensou...@diasemi.com> > > > > > > Add DA9062 OnKey support into the existing DA9063 OnKey driver component > > > by > > > using generic access tables for common register and bit mask definitions. > > > > > > The following change will add generic register and bit mask support to the > > > DA9063 OnKey. > > > > > > The following alterations have been made to the DA9063 OnKey: > > > > > > - Addition of a da906x_chip_config structure to hold all > > > generic registers and bitmasks for this type of OnKey component. > > > - Addition of an struct of_device_id table for DA9063 and DA9062 > > > defaults > > > - Refactoring functions to use struct da9063_onkey accesses to generic > > > registers/masks instead of using defines from registers.h > > > - Re-work of da9063_onkey_probe() to use of_match_node() and > > > dev_get_regmap() to provide initialisation of generic registers and > > > masks and access to regmap > > > > > > Signed-off-by: Steve Twiss <stwiss.opensou...@diasemi.com> > > > Signed-off-by: Dmitry Torokhov <dmitry.torok...@gmail.com> > > > --- > > > .../devicetree/bindings/input/da9062-onkey.txt | 32 +++++ > > > drivers/input/misc/Kconfig | 8 + > > > drivers/input/misc/da9063_onkey.c | 129 > > > ++++++++++++++++---- > > > 3 files changed, 140 insertions(+), 29 deletions(-) > > > create mode 100644 > > > Documentation/devicetree/bindings/input/da9062-onkey.txt > > > > I'm confused. What's the dependency? > > > > There shouldn't be any issue applying input patches, just because > > there isn't an MFD counterpart. In fact, I would take prior > > acceptance of the child into consideration (would be like a +1 vote) > > when reviewing the MFD part. > > It's this chunk: > > +#include <linux/mfd/da9062/core.h> > +#include <linux/mfd/da9062/registers.h> > > and these header files are not in mainline yet. Ah, thanks for the clarification. I will apply the other patches. > > One suggestion however, I would ask for the DT binding and the driver > > to be separated, as per [0]. > > > > [0] Documentation/devicetree/bindings/submitting-patches.txt > > Right, but that says about submitting patches, not applying them ;) > > When I chatted with Grant he said that the policy of separating binding > and code into separate patches is done so not to overwhelm devicetree > list and that is is perfectly fine to actually apply them as a single > commit. I try to combine them together so that when looking through > history they show up as one. Got you. :) -- Lee Jones Linaro STMicroelectronics Landing Team Lead Linaro.org │ Open source software for ARM SoCs Follow Linaro: Facebook | Twitter | Blog -- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
