On Wednesday, September 02, 2015 at 07:12:14 PM, Ranjit Abhimanyu Waghmode wrote: > Hi Marek, > > > -----Original Message----- > > From: Marek Vasut [mailto:ma...@denx.de] > > Sent: Wednesday, August 26, 2015 12:26 PM > > To: Ranjit Abhimanyu Waghmode > > Cc: dw...@infradead.org; computersforpe...@gmail.com; > > broo...@kernel.org; Michal Simek; Soren Brinkmann; zaj...@gmail.com; > > b...@decadent.org.uk; b32...@freescale.com; knut.wohl...@de.bosch.com; > > juh...@openwrt.org; bean...@micron.com; linux-...@lists.infradead.org; > > linux-kernel@vger.kernel.org; linux-...@vger.kernel.org; linux-arm- > > ker...@lists.infradead.org; Harini Katakam; Punnaiah Choudary Kalluri > > Subject: Re: [LINUX RFC v2 0/4] spi: add dual parallel mode support in > > Zynq MPSoC GQSPI controller > > > > On Wednesday, August 26, 2015 at 08:26:03 AM, Ranjit Waghmode wrote: > > > This series adds dual parallel mode support for Zynq Ultrascale+ MPSoC > > > GQSPI controller driver. > > > > > > What is dual parallel mode? > > > --------------------------- > > > ZynqMP GQSPI controller supports Dual Parallel mode with following > > > functionalities: 1) Supporting two SPI flash memories operating in > > > parallel. 8 I/O lines. 2) Chip selects and clock are shared to both > > > the flash devices > > > 3) This mode is targeted for faster read/write speed and also doubles > > > the size 4) Commands/data can be transmitted/received from both the > > > devices(mirror), or only upper or only lower flash memory devices. > > > > > > 5) Data arrangement: > > > With stripe enabled, > > > Even bytes i.e. 0, 2, 4,... are transmitted on Lower Data Bus > > > Odd bytes i.e. 1, 3, 5,.. are transmitted on Upper Data Bus. > > > > This might be a dumb question, but why don't you just treat this as an > > SPI NOR flash with 8-bit bus ? > > In case of dual parallel configuration of this controller there are > different modes like single, dual and quad mode. Whatever you are > suggesting would fit only in the case of Quad mode operation as both buses > would have 4 lines each. In case of single mode of parallel configuration, > there would be two buses; but the line on each bus would one. So > altogether there will be two lines. And in case of dual mode of parallel > configuration each bus will be having two lines. So altogether 4 lines > will be there. So keeping 8 lines would not support above two modes of > parallel configuration correctly. > > Logically it is a single flash with 8 IO lines but physically it's a two > flash devices and each has 4 IO lines. So, in this case, read and write > addresses should be always even and minimum data that can be accessed is 2 > bytes.
Oh, I see what the issue is now. It has to do with configuring the flash into correct bus-width mode, right ? Best regards, Marek Vasut -- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/