Hi I'm running Debian with kernel: 2.6.24-etchnhalf.1-686
I recently baught a TeVii S420 DVB-S card and have been tring to get it
to work.
Firstly i built the v4l from: http://linuxtv.org/hg/v4l-dvb (hg clone)
as the card was not detected.
On first reboot after new modules are installed i get a kernel soft
lockup....
-------------------------------------------------
Linux video capture interface: v2.00
cx88/0: cx2388x v4l2 driver version 0.0.6 loaded
ACPI: PCI Interrupt Link [APC3] enabled at IRQ 18
ACPI: PCI Interrupt 0000:05:08.0[A] -> Link [APC3] -> GSI 18 (level,
low) -> IRQ 21
cx88[0]: subsystem: d420:9022, board: TeVii S420 DVB-S
[card=73,autodetected], frontend(s): 1
cx88[0]: TV tuner type -1, Radio tuner type -1
cx88/2: cx2388x MPEG-TS Driver Manager version 0.0.6 loaded
tuner' 2-0068: chip found @ 0xd0 (cx88[0])
cx88[0]/0: found at 0000:05:08.0, rev: 5, irq: 21, latency: 32, mmio:
0xd8000000
cx88[0]/0: registered device video0 [v4l2]
cx88[0]/0: registered device vbi0
tuner' 2-0068: tuner type not set
cx88[0]/2: cx2388x 8802 Driver Manager
ACPI: PCI Interrupt 0000:05:08.2[A] -> Link [APC3] -> GSI 18 (level,
low) -> IRQ 21
cx88[0]/2: found at 0000:05:08.2, rev: 5, irq: 21, latency: 32, mmio:
0xd9000000
ACPI: PCI Interrupt Link [APCJ] enabled at IRQ 22
ACPI: PCI Interrupt 0000:00:04.0[A] -> Link [APCJ] -> GSI 22 (level,
low) -> IRQ 17
cx88/2: cx2388x dvb driver version 0.0.6 loaded
cx88/2: registering cx8802 driver, type: dvb access: shared
cx88[0]/2: subsystem: d420:9022, board: TeVii S420 DVB-S [card=73]
cx88[0]/2: cx2388x based DVB/ATSC card
BUG: soft lockup - CPU#0 stuck for 11s! [modprobe:1767]
Pid: 1767, comm: modprobe Not tainted (2.6.24-etchnhalf.1-686 #1)
EIP: 0060:[<c02be0a5>] EFLAGS: 00000286 CPU: 0
EIP is at _spin_lock+0x7/0xf
EAX: [removed]
ESI: [removed]
DS: [removed]
CR0: [removed]
DR0: [removed]
DR6: [removed]
[<c02bd4ba>] __mutex_lock_slowpath+0x17/0x7f
[<c01099da>] sched_clock+0x8/0x18
[<c02bd39a>] mutex_lock+0xa/0xb
[<f89d60f7>] videobuf_dvb_get_frontend+0x11/0x37 [videobuf_dvb]
[<f8a4e3b2>] cx8802_dvb_probe+0xef/0x1a15 [cx88_dvb]
[<c0121da0>] check_preempt_wakeup+0x1e/0x7a
[<f89de540>] cx8802_register_driver+0x128/0x1e3 [ex8802]
[<c01437ab>] sys_int_module+0x15e3/0x16fb
[<c0164172>] vma_prio_tree_insert+0x17/0x2a
[<c012c887>] msleep+0x0/0x12
[<c0103e66>] sysenter_past_esp+0x6b/0xa1
==============================
Only way i can boot my system is to remove the PCI card.
So then i tried using the drivers from TeVii (
http://www.tevii.com/Tevii_linuxdriver_0815.rar )
These actually work but are based on what seems to be a v4l-dvb checkout
from 2008-08-14.
I can't use these old drivers because they conflict with other v4l-dvb
modules i want to load for other tuner cards.
Is there someway i can get the TeVii S420 working on the latest v4l-dvb
modules?
Also using the old drivers, just the following happens on boot
-----------
cx88[0]/2: subsystem: d420:9022, board: TeVii S420 DVB-S [card=73]
cx88[0]/2: cx2388x based DVB/ATSC card
intel8x0_measure_ac97_clock: measured 54726 usecs
intel8x0: clocking to 46908
stv0288 id 11
DVB: registering new adapter (cx88[0])
DVB: registering frontend 0 (ST STV0288 DVB-S)...
-----------
Could this perhaps be an issue with the intel8x0 module?
-------------------------------------------------
--
To unsubscribe from this list: send the line "unsubscribe linux-media" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
