Thanks for the response! Replies are in line. On Thu, Sep 16, 2010 at 6:48 PM, Andy Walls <awa...@md.metrocast.net> wrote: > On Wed, 2010-09-15 at 22:54 -0400, Josh Borke wrote: >> I've recently noticed some distortion coming from my hvr1600 when >> viewing analog channels. It happens to all analog channels with some >> slightly better than others. I am running Fedora 12 linux with kernel >> version 2.6.32.21-166. > > >> I know I need to include more information but I'm not sure what to >> include. Any help would be appreciated. > > 1. Would you say the distortion is something you would possibly > encounter on an analog television set, or does it look "uniquely > digital"? On systems with a long uptime and lots of usage, MPEG encoder > firmware could wind up in a screwed up state giving weird output image. > Simple solution in this case is to reboot.
I'm not sure if I would classify it as "uniquely digital". The distortion happens across most of the screen with it being concentrated in the top third. Additionally shows that include black bars the top black bar is seemingly stretched and the image seems like the colors are over-saturated where they colors are brighter. Rebooting had no effect :( > > 2. Have you ensured your cable plant isn't affecting signal integrity? > http://ivtvdriver.org/index.php/Howto:Improve_signal_quality The cable plant hasn't changed the signal strength or integrity as far as I know. > > > 3. Does this happen with only the RF tuner or only CVBS or only SVideo > or more than one of them? If the problem is only with RF, then it could > be an incoming signal distortion problem. Do you have cable or an over > the air antenna for analog RF? I only have input for the RF tuner. I have cable for analog RF. > > 4. What does v4l2-ctl --log-status show as your analog tuner? Not sure what you mean so I've included the full output: # v4l2-ctl -d /dev/hvr1600 --log-status Status Log: cx18-0: ================= START STATUS CARD #0 ================= cx18-0: Version: 1.2.0 Card: Hauppauge HVR-1600 tveeprom 3-0050: Hauppauge model 74041, rev C6B2, serial# 898361 tveeprom 3-0050: MAC address is 00-0D-FE-0D-B5-39 tveeprom 3-0050: tuner model is TCL M2523_5N_E (idx 112, type 50) tveeprom 3-0050: TV standards NTSC(M) (eeprom 0x08) tveeprom 3-0050: audio processor is CX23418 (idx 38) tveeprom 3-0050: decoder processor is CX23418 (idx 31) tveeprom 3-0050: has no radio, has IR receiver, has IR transmitter cx18-0 843: Video signal: present cx18-0 843: Detected format: NTSC-M cx18-0 843: Specified standard: NTSC-M cx18-0 843: Specified video input: Composite 7 cx18-0 843: Specified audioclock freq: 48000 Hz cx18-0 843: Detected audio mode: mono cx18-0 843: Detected audio standard: BTSC cx18-0 843: Audio muted: no cx18-0 843: Audio microcontroller: running cx18-0 843: Configured audio standard: automatic detection cx18-0 843: Configured audio system: BTSC cx18-0 843: Specified audio input: Tuner (In8) cx18-0 843: Preferred audio mode: stereo cx18-0 gpio-reset-ctrl: GPIO: direction 0x00003001, value 0x00003001 tuner 4-0061: Tuner mode: analog TV tuner 4-0061: Frequency: 175.25 MHz tuner 4-0061: Standard: 0x0000b000 cs5345 3-004c: Input: 1 cs5345 3-004c: Volume: 0 dB cx18-0: Video Input: Tuner 1 cx18-0: Audio Input: Tuner 1 cx18-0: GPIO: direction 0x00003001, value 0x00003001 cx18-0: Tuner: TV cx18-0: Stream: MPEG-2 Program Stream cx18-0: VBI Format: Private packet, IVTV format cx18-0: Video: 720x480, 30 fps cx18-0: Video: MPEG-2, 4x3, Variable Bitrate, 6600000, Peak 6600000 cx18-0: Video: GOP Size 15, 2 B-Frames, GOP Closure cx18-0: Audio: 48 kHz, MPEG-1/2 Layer II, 384 kbps, Stereo, No Emphasis, No CRC cx18-0: Spatial Filter: Manual, Luma 1D Horizontal, Chroma 1D Horizontal, 0 cx18-0: Temporal Filter: Manual, 8 cx18-0: Median Filter: Off, Luma [0, 255], Chroma [0, 255] cx18-0: Status flags: 0x00200001 cx18-0: Stream encoder MPEG: status 0x0000, 0% of 2048 KiB (64 buffers) in use cx18-0: Stream encoder YUV: status 0x0000, 0% of 2048 KiB (16 buffers) in use cx18-0: Stream encoder VBI: status 0x0000, 0% of 1015 KiB (20 buffers) in use cx18-0: Stream encoder PCM audio: status 0x0000, 0% of 1024 KiB (256 buffers) in use cx18-0: Read MPEG/VBI: 3507263488/15001920 bytes cx18-0: ================== END STATUS CARD #0 ================== > 5. Do you have a kernel with the new concurrency managed workqueues? > On these kernels 'ps axf' will *not* show kernel threads with names like > [cx18-0-in], [cx18-0-out/0], [cx18-0-out/1]. This is a major kernel > change which could cause some MPEG buffers to be lost or reordered, if > the new workqueue implementation has bugs. > ps axf shows [cx18-0-in], [cx18-0-out/0], [cx18-0-out/1], [cx18-0-out/2], [cx18-0-out/3] > 6. Have you recently installed new hardware in the subject computer? Of > most interest are adapter cards with cables coming off of them and cards > very close to the HVR-1600. EMI can be picked up by the HVR-1600's > board traces that are not shielded. > Haven't changed any of the hardware in the system. > 7. Does the distortion look like loss of horizontal line sync and happen > only near very bright parts of the image on the left edge? If it does, > the baseband video signal level is too high. It does seem to be worse in brighter areas of the screen. Inserting additional splitters (to reduce the signal strength) has no affect. > > 8. Care to post a short image in a paste bin or email a small MPEG to > me? I've tried using $ ivtv-tune -c 71 -d /dev/hvr1600 followed by $ cat /dev/hvr1600 > /tmp/test.mpg then ctrl+c'ing that after a few seconds but it results in garbage. Do you have a better method? I'll email you that file so you can see it anyway. Most of my recordings are from using mythtv and the results are at least watchable. > Regards, > Andy > > > Thanks again! -josh PS: I have a Trilithic model 3 cable tester so I can give you exact signal strength going to the card if that would help. -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
