On Fri, Jul 22, 2011 at 12:59 AM, Bryan Buckley <bryan.buck...@ti.com> wrote:
> Remove OMAP4_USBC1_ICUSB_PWRDNZ_MASK during enable/disable PWRDNZ mode for
> MMC1_PBIAS and associated extended-drain MMC1 I/O cell. This is in accordance
> with the control module programming guide. This fixes a bug where if trying to
> use gpio_98 or gpio_99 and MMC1 at the same time the GPIO signal will be
> affected by a changing SDMMC1_VDDS.
>
> Software must keep MMC1_PBIAS cell and MMC1_IO cell PWRDNZ signals low
> whenever
> SDMMC1_VDDS ramps up/down or changes for cell protection purposes.
>
> MMC1 is based on SDMMC1_VDDS whereas USBC1 is based on SIM_VDDS therefore
> they can operate independently.
>
> Signed-off-by: Bryan Buckley <bryan.buck...@ti.com>
Good catch,
Acked-by: Kishore Kadiyala <kishore.kadiy...@ti.com>
> ---
> arch/arm/mach-omap2/hsmmc.c | 12 ++++--------
> 1 files changed, 4 insertions(+), 8 deletions(-)
>
> diff --git a/arch/arm/mach-omap2/hsmmc.c b/arch/arm/mach-omap2/hsmmc.c
> index 3842405..a6135df 100644
> --- a/arch/arm/mach-omap2/hsmmc.c
> +++ b/arch/arm/mach-omap2/hsmmc.c
> @@ -144,8 +144,7 @@ static void omap4_hsmmc1_before_set_reg(struct device
> *dev, int slot,
> */
> reg = omap4_ctrl_pad_readl(control_pbias_offset);
> reg &= ~(OMAP4_MMC1_PBIASLITE_PWRDNZ_MASK |
> - OMAP4_MMC1_PWRDNZ_MASK |
> - OMAP4_USBC1_ICUSB_PWRDNZ_MASK);
> + OMAP4_MMC1_PWRDNZ_MASK);
> omap4_ctrl_pad_writel(reg, control_pbias_offset);
> }
>
> @@ -165,8 +164,7 @@ static void omap4_hsmmc1_after_set_reg(struct device
> *dev, int slot,
> else
> reg |= OMAP4_MMC1_PBIASLITE_VMODE_MASK;
> reg |= (OMAP4_MMC1_PBIASLITE_PWRDNZ_MASK |
> - OMAP4_MMC1_PWRDNZ_MASK |
> - OMAP4_USBC1_ICUSB_PWRDNZ_MASK);
> + OMAP4_MMC1_PWRDNZ_MASK);
> omap4_ctrl_pad_writel(reg, control_pbias_offset);
> /* 4 microsec delay for comparator to generate an error*/
> udelay(4);
> @@ -174,16 +172,14 @@ static void omap4_hsmmc1_after_set_reg(struct device
> *dev, int slot,
> if (reg & OMAP4_MMC1_PBIASLITE_VMODE_ERROR_MASK) {
> pr_err("Pbias Voltage is not same as LDO\n");
> /* Caution : On VMODE_ERROR Power Down MMC IO */
> - reg &= ~(OMAP4_MMC1_PWRDNZ_MASK |
> - OMAP4_USBC1_ICUSB_PWRDNZ_MASK);
> + reg &= ~(OMAP4_MMC1_PWRDNZ_MASK);
> omap4_ctrl_pad_writel(reg, control_pbias_offset);
> }
> } else {
> reg = omap4_ctrl_pad_readl(control_pbias_offset);
> reg |= (OMAP4_MMC1_PBIASLITE_PWRDNZ_MASK |
> OMAP4_MMC1_PWRDNZ_MASK |
> - OMAP4_MMC1_PBIASLITE_VMODE_MASK |
> - OMAP4_USBC1_ICUSB_PWRDNZ_MASK);
> + OMAP4_MMC1_PBIASLITE_VMODE_MASK);
> omap4_ctrl_pad_writel(reg, control_pbias_offset);
> }
> }
> --
> 1.7.0.4
>
> --
> To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
> the body of a message to majord...@vger.kernel.org
> More majordomo info at http://vger.kernel.org/majordomo-info.html
>
--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
