I just recently purchased a Netgear 10/100 NIC that uses the tulip driver.
But now I'm experiancing intermittant lockups. The recieve module seems
to lock up and I start getting buffer overflows. I've also experianced
general protection faults since installing this card. The car works okay
as long as there is a low volume of traffic - like web surfing. But try to
start a shared application and the card lock up. If I take the interface
down and then restart it, it's back in business until someone trys to move
a lot of data across the link. I've run tulip-diag when the card locks up
and it reports the RX process state is stalled. Any ideas? For the time
being, I think I'll revert to the 10BaseT card that was previously in the
machine.
TIA for any suggestions.
Dale W Hodge [EMAIL PROTECTED], [EMAIL PROTECTED]
Web Page: www.dwh.dyn.ml.org , www.dnd.ddns.org
-
To unsubscribe from this list: send the line "unsubscribe linux-net" in
the body of a message to [EMAIL PROTECTED]
