Hello Linux Guru's,
I'm new to this and need some assistance. I've installed RedHat 5.2
and can't get my 3Com NIC to work. I've tried reading as much as I could
about it and searching the internet but with no luck. Would someone guide
me thru the steps I need to get the NIC up and running? Here are the info
messages that come up during bootup:
Nov 5 10:59:08 scb kernel: 3c59x.c:v0.99 4/7/98 Donald Becker
http://cesdis.gsfc.nasa.gov/linux/drivers/vortex.html
Nov 5 10:59:08 scb kernel: loading device 'eth0'...
Nov 5 10:59:08 scb kernel: eth0: 3Com 3c905B Cyclone 100baseTx at 0x1000,
ff:ff:ff:ff:ff:ff, IRQ 11
Nov 5 10:59:08 scb kernel: 1024K word-wide RAM 3:5 Rx:Tx split,
autoselect/undefined interface.
Nov 5 10:59:08 scb kernel: Enabling bus-master transmits and early
receives.
Nov 5 10:59:14 scb kernel: eth0: transmit timed out, tx_status ff status
ffff.
Nov 5 10:59:14 scb kernel: eth0: Transmitter encountered 16 collisions --
network cable problem?
Nov 5 10:59:14 scb kernel: eth0: Interrupt posted but not delivered -- IRQ
blocked by another device?
Nov 5 10:59:14 scb kernel: eth0: Updating statistics failed, disabling
stats as an interrupt source.
Nov 5 10:59:14 scb kernel: eth0: Host error, FIFO diagnostic register ffff.
TIA!!
Steve D. Burke, MSgt, USAF,
Chief, Network Management, MCSE, MCP, CNA
24 CS/SCBM Howard AFB, Republic of Panama
E-Mail Address - [EMAIL PROTECTED]
Voice - DSN 313-284-5418/ Comm 011-507-284-5418
Fax - DSN 313-284-4899 / Comm 011-507-284-4899
-
To unsubscribe from this list: send the line "unsubscribe linux-net" in
the body of a message to [EMAIL PROTECTED]
