On Thu, 12 Aug 1999, Trenton D. Adams wrote:
> If it is in fact an NE2000 compatible, you can go "modprobe ne.o". Then go
> "ifconfig eth0 192.168.1.1". Then "route add -net 192.168.1.0 eth0"
There is ne2k-pci.o for a PCI NE2000 compatible.
Command : "insmod ne irq=5,io=0x0280"
--
>
> -----Original Message-----
> From: [EMAIL PROTECTED]
> [mailto:[EMAIL PROTECTED]] On Behalf Of Joshua S. Freeman
> Sent: August 11, 1999 8:55 AM
> To: [EMAIL PROTECTED]
> Subject: terrible time with an HP pavilion 4440
>
> I'm a total newbie so please go easy on me.
>
> I'm trying to setup an HP pavilion as a dual-boot win98 and Linux 6.0 with
> networking using a LinkSys Ether16 LAN card.
>
> To begin, I was able to install the card and get it running properly under
> win98 by using the card in pnp mode.
>
> It's using the NE2000 compatible driver. It's IRQ is automagically set to
> 5 and it's I/O automagically set to 0280-029F
>
> when I boot into Linux, of course the eth0 initialization is 'delayed' and
> 'failed'.
>
> I used linuxconf to set the settings the same as they are in Win98, but no
> luck.
>
> I've also had no luck by, after the fact, going back into the card config.
> software under DOS and disabling the PNP.
>
> I'm truly lost.
>
> Any help appreciated.
>
> J.
-
To unsubscribe from this list: send the line "unsubscribe linux-net" in
the body of a message to [EMAIL PROTECTED]
