using 'mii-diag -A 100baseTx' shows the following.
Using the default interface 'eth0'.
Setting the media capability advertisement register of PHY #0 to 0x0181.
Basic registers of MII PHY #0: c000 c000 c000 c000 c000 c000 c000 c000.
Basic mode control register 0xc000: Auto-negotiation disabled, with
Speed fixed at 10mbps, half-duplex.
Transceiver in loopback mode!
Transceiver currently being reset!
Basic mode status register 0xc000 ... c000.
Link status: not established.
Your link partner can do c000:.
I am not sure what this means but it looks like it did not work.
Also, I realized that I transposed the "59" with "95" in 3c59x after
reading the orginal message. Guess I was in a hurry this afternoon.
At 06:53 PM 9/8/99 -0400, you wrote:
>Try using donald's mii-diag from his page at cesdis..
>
>http://cesdis1.gsfc.nasa.gov/linux/diag/
>
>use mii-diag -A mediatype
>
>hth,
>Arni
>
>
>LaRoy McCann wrote:
>>
>> I have a 3c905b-tx card and an smc card setup as a router for 2 networks.
>> (192.6.21.0 and 192.168.1.0)
>>
>> Everything works now, but I can not get the 3com nic to work at 100Tx.
>> When I first boot the router (Redhat 6.0 / 2.2.5-15) the 100mb light lights
>> up on the linksys etherfast 10/100 8-port hub.
>> As the system configures the either ports the light goes out, then back on
>> at only 10mb.
>>
>> I have tried the latest 3c95x code, .99L, which did not help. But, as I
>> was testing I noted that "insmod 3c95x" will leave the light at 100mb. It
>> is when I do the "ifconfig eth0 192.168.1.1 netmask 255.255.255.0" that the
>> light goes off and back on to 10mb.
>>
>> I tryed to use the "ifconfig eth0 192.168.1.1 media 100baseTx", but that
>> gives the following error.
>> "SIOCSIFMAP: Operation not supported"
>>
>> dmesg gives the following lines about the card.
>> "eth0: 3Com 3c905B Cyclone 100baseTx at 0xfc00, ***INVALID CHECKSUM
>> 000a*** 00:10:5a:62:d9:41, IRQ 10"
>> "8K byte-wide RAM 5:3 Rx:Tx split, 100baseTX interface."
>> "Enabling bus-master transmits and whole-frame receives."
>>
>> Is ifconfig broken? (ifconfig version 1.39 / net-tools version 1.51)
>>
>> LaRoy McCann
>> Electrical Engineering Manager
>> Roach Conveyors
>> Hwy 463 N.
>> Trumann, AR 72472
>> (870) 483-7631 x638 voice
>> (870) 483-7049 fax
>> [EMAIL PROTECTED]
>> -
>> To unsubscribe from this list: send the line "unsubscribe linux-net" in
>> the body of a message to [EMAIL PROTECTED]
>-
>To unsubscribe from this list: send the line "unsubscribe linux-net" in
>the body of a message to [EMAIL PROTECTED]
>
-
To unsubscribe from this list: send the line "unsubscribe linux-net" in
the body of a message to [EMAIL PROTECTED]
