Is there a way to load the sat card module first? If it automatically picks
up eth1, when the Intel module loads after it should (theoretically) pick
eth0 and eth2. I'm assuming here that the sat card doesn't use the same
module!
-----Original Message-----
From: Federico Figueroa C. [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, October 27, 1999 1:04 AM
To: [EMAIL PROTECTED]
Subject: how to set intel NICs to be eth0 and eth2 but no eth1
Hi... I have two Intel network cards (eepro100), and iI need them
to be eth0 and eth2 because I have antoher card, an satellite reciever
that is handleded as a ethernet card that have to be eth1 because of the
software that is needed for it to work... and I have no way to change
it... it's closed software...
I alredy try with the line
append= "ether=10,0xdc00,eth0 ether=9,0xdc80,eth1 ether=11,0xd880,eth2"
on the lilo.conf file and run lilo... but it doesn't work... the
driver finds all the intel cards and assign eth0 and eth1 to them... is
there a way to load the module and tell it to look only one at a
time... or any other way to do this...?
TIA
Federico Figueroa C. .~.
ISPW S.A. /V\ L I N U X
Proyectos Especiales // \\ >Don't fear the penguin<
Departamento de C�mputo /( )\
^^-^^
/*In a world without walls and fences who needs windows and gates*/
-
To unsubscribe from this list: send the line "unsubscribe linux-net" in
the body of a message to [EMAIL PROTECTED]
-
To unsubscribe from this list: send the line "unsubscribe linux-net" in
the body of a message to [EMAIL PROTECTED]
