>
> All
>
> I'm having a hard time configuring networking on my Linux box (RH 5.2 kernel
> 2.0.36, AMD K2-350, 64MB). More specifically getting the Tulip module to
> load for eth0. I have an Accton Cheetah (EN1207D-TX) PCI NIC, which is
> jumperless plug n play. I know from the BIOS info shown at boot up that it
> uses IRQ 9, but I need to know the Base i/o address to load the module. My
> question is, has anyone managed to get this particular adapter working with
> linux (if so any hints on the base i/o address would be helpful) or can
> anyone suggest a way of finding out the Base I/O address.
>
> TIA
>
> Ailwyn
>
I have no such card, but: I have an ethernet card that have two distinct
modes: pnp and jumperless. With a DOS utility you can switch between them
and set base i/o & irq for the jumperless mode.
--
-----------------------------------
..=KJM*&OOZ=.. . Alfredo Braunstein
.:KJG#'" '"YYTR._ .F`
.FHGH" ""HJH .F` <[EMAIL PROTECTED]>
JHHJK HHJ. , <[EMAIL PROTECTED]>
'JHHK. .FN` "NH..&` -----------------------------------
'JHJH;.. _.;FG` `KK` Due to circumstances beyond your
""HJHJHJGDGNM;`` .P`.N, control you are master of your
''"""""' O` '% fate and captain of your soul
B. . O -----------------------------------
'MM%`
.
