If you choose default output to DVI, the LCD backlight used to
stay on, since panel->disable function never gets called.
So, during init put backlight GPIO to off state and the driver
code will decide which output to enable.
Signed-off-by: Vaibhav Hiremath <hvaib...@ti.com>
---
arch/arm/mach-omap2/board-omap3evm.c | 10 ++++++++--
1 files changed, 8 insertions(+), 2 deletions(-)
diff --git a/arch/arm/mach-omap2/board-omap3evm.c
b/arch/arm/mach-omap2/board-omap3evm.c
index 0d235bc..2a2efa9 100644
--- a/arch/arm/mach-omap2/board-omap3evm.c
+++ b/arch/arm/mach-omap2/board-omap3evm.c
@@ -444,6 +444,8 @@ static struct platform_device leds_gpio = {
static int omap3evm_twl_gpio_setup(struct device *dev,
unsigned gpio, unsigned ngpio)
{
+ int r;
+
/* gpio + 0 is "mmc0_cd" (input/IRQ) */
omap_mux_init_gpio(63, OMAP_PIN_INPUT);
mmc[0].gpio_cd = gpio + 0;
@@ -459,8 +461,12 @@ static int omap3evm_twl_gpio_setup(struct device *dev,
*/
/* TWL4030_GPIO_MAX + 0 == ledA, LCD Backlight control */
- gpio_request(gpio + TWL4030_GPIO_MAX, "EN_LCD_BKL");
- gpio_direction_output(gpio + TWL4030_GPIO_MAX, 0);
+ r = gpio_request(gpio + TWL4030_GPIO_MAX, "EN_LCD_BKL");
+ if (!r)
+ r = gpio_direction_output(gpio + TWL4030_GPIO_MAX,
+ (get_omap3_evm_rev() >= OMAP3EVM_BOARD_GEN_2) ? 1 : 0);
+ if (r)
+ printk(KERN_ERR "failed to get/set lcd_bkl gpio\n");
/* gpio + 7 == DVI Enable */
gpio_request(gpio + 7, "EN_DVI");
--
1.6.2.4
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
