On Thu, May 3, 2012 at 11:03 PM, Igor Grinberg <grinb...@compulab.co.il> wrote: > Hi Russ, > > On 05/03/12 22:08, Russ Dill wrote: >> On Wed, May 2, 2012 at 3:38 AM, Raja, Govindraj <govindraj.r...@ti.com> >> wrote: >>> On Wed, May 2, 2012 at 2:17 PM, Russ Dill <russ.d...@ti.com> wrote: >>>> On Mon, Mar 19, 2012 at 6:34 AM, Raja, Govindraj <govindraj.r...@ti.com> >>>> wrote: >>>>> On Mon, Mar 19, 2012 at 12:12 PM, Keshava Munegowda >>>>> <keshava_mgo...@ti.com> wrote: >>>>>> From: Keshava Munegowda <keshava_mgo...@ti.com> >>>>>> >>>>>> It is observed that the echi ports of 3430 sdp board >>>>>> are not working due to the random timing of programming >>>>>> the associated GPIOs of the ULPI PHYs of the EHCI for reset. >>>>>> If the PHYs are reset at during usbhs core driver, host ports will >>>>>> not work because EHCI driver is loaded after the resetting PHYs. >>>>>> The PHYs should be in reset state while initializing the EHCI >>>>>> controller. >>>>>> The code which does the GPIO pins associated with the PHYs >>>>>> are programmed to reset is moved from the USB host core driver >>>>>> to EHCI driver. >>>>> >>>>> I tested on beagle xm where gpio nreset is requested from >>>>> board file. >>>>> (Basic enumertaion after gpio nreset seems to work fine, >>>>> Hub and smsc lan chip get detected afetr boot up) >>>>> >>>> >>>> What base did you test this on top of? my xM is failing USB-wise when >>>> I apply this on v3.3.3 (with the UART mux fix patch) and where it is >>>> applied within master (3.4-rc4, again, with the UART mux fix patch). >>>> Additionally, reverting this patch from 3.4-rc5 causes rc5 to work >>>> properly. >>>> >>> >>> Works for me be on 3.4-rc5 Beagle-XM even without reverting the patch >>> >>> Logs as in here [1]. >>> >>> -- >>> Thanks, >>> Govindraj.R >>> >>> [1]: >>> http://pastebin.pandaboard.org/index.php/view/20343533 >> >> I've tracked down the difference. I'm loading my uEnv.txt and uImage >> in u-boot from the network which means initializing USB. You are >> loading straight from MMC. If I switch to loading straight from MMC >> everything works. >> >> Can everyone do a 'usb start' in u-boot before booting and re-test? >> I'm pretty sure this is a regression, but the bug could be a strange >> u-boot/kernel interaction. > > Probably, kernel code does not reinitialize EHCI correctly if it was already > enabled? > Can you try the below sequence: > usb start > usb stop > boot Linux
That doesn't work. Rebooting does work though. -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html