Hi Marc, > Subject: Re: [PATCH v3] can: rcar_canfd: Add Renesas R-Car CAN FD driver > > On 03/15/2016 10:48 AM, Ramesh Shanmugasundaram wrote: > > This patch adds support for the CAN FD controller found in Renesas > > R-Car SoCs. The controller operates in CAN FD only mode by default. > > > > CAN FD mode supports both Classical CAN & CAN FD frame formats. The > > controller supports ISO 11898-1:2015 CAN FD format only. > > > > This controller supports two channels and the driver can enable either > > or both of the channels. > > > > Driver uses Rx FIFOs (one per channel) for reception & Common FIFOs > > (one per channel) for transmission. Rx filter rules are configured to > > the minimum (one per channel) and it accepts Standard, Extended, Data > > & Remote Frame combinations. > > > > Note: There are few documentation errors in R-Car Gen3 Hardware User > > Manual v0.5E with respect to CAN FD controller. They are listed below: > > > > 1. CAN FD interrupt numbers 29 & 30 are listed as per channel > > interrupts. However, they are common to both channels (i.e.) they are > > global and channel interrupts respectively. > > > > 2. CANFD clock is derived from PLL1. This is not documented. > > > > 3. CANFD clock is further divided by (1/2) within the CAN FD controller. > > This is not documented. > > > > 4. The minimum value of NTSEG1 in RSCFDnCFDCmNCFG register is 2 Tq. It > > is specified 4 Tq in the manual. > > > > 5. The maximum number of message RAM area the controller can use is > > 3584 bytes. It is specified 10752 bytes in the manual. > > > > Signed-off-by: Ramesh Shanmugasundaram > > <ramesh.shanmugasunda...@bp.renesas.com> > > --- > > Hi All, > > > > Thanks for the review comments. > > > > This updated patch is based on linux-can-next tag (linux-can-next- > for-4.6-20160310). > > > > This patch depends on > > > > [RFC] [PATCH v3] can: fix handling of unmodifiable configuration > options > > (http://comments.gmane.org/gmane.linux.can/9126) > > > > Changes since v2: > > * Rebased to latest tag (linux-can-next-for-4.6-20160310) > > * Cleaned up leftover debugfs code (Thanks Oliver H) > > * Revised devicetree documentation text (as suggested by Rob H) > > (https://www.mail-archive.com/linux-renesas- > s...@vger.kernel.org/msg01597.html) > > * Used new can subsystem api to set static configuration & removed > check in rcar_canfd_start (as suggested by Oliver H) > > (Refer: http://comments.gmane.org/gmane.linux.can/9126 & > > https://www.mail-archive.com/linux-renesas- > s...@vger.kernel.org/msg01867.html) > > * Clubbed Renesas controller drivers to driver/net/can/rcar dir (as > > suggested by Oliver H) > > Please make moving of the existing drivers a separate patch.
OK. I'll submit new patch with CAN FD driver in new "rcar" dir and will provide a separate patch on top that will move the CAN driver to "rcar" dir. Thanks, Ramesh
