On Sat, 7 Jun 2014, Abhilash Kesavan wrote: > Hi Nicolas, > > The first man of the incoming cluster enables its snoops via the > power_up_setup function. During secondary boot-up, this does not occur > for the boot cluster. Hence, I enable the snoops for the boot cluster > as a one-time setup from the u-boot prompt. After secondary boot-up > there is no modification that I do.
OK that's good. > Where should this be ideally done ? If I remember correctly, the CCI can be safely activated only when the cache is disabled. So that means the CCI should ideally be turned on for the boot cluster (and *only* for the boot CPU) by the bootloader. Now... If you _really_ prefer to do it from the kernel to avoid difficulties with bootloader updates, then it should be possible to do it from the kernel by temporarily turning the cache off. This is not a small thing but the MCPM infrastructure can be leveraged. Here's what I tried on a TC2 which might just work for you as well: diff --git a/arch/arm/common/mcpm_entry.c b/arch/arm/common/mcpm_entry.c index 86fd60fefb..1cc49de308 100644 --- a/arch/arm/common/mcpm_entry.c +++ b/arch/arm/common/mcpm_entry.c @@ -12,11 +12,13 @@ #include <linux/kernel.h> #include <linux/init.h> #include <linux/irqflags.h> +#include <linux/cpu_pm.h> #include <asm/mcpm.h> #include <asm/cacheflush.h> #include <asm/idmap.h> #include <asm/cputype.h> +#include <asm/suspend.h> extern unsigned long mcpm_entry_vectors[MAX_NR_CLUSTERS][MAX_CPUS_PER_CLUSTER]; @@ -146,6 +148,44 @@ int mcpm_cpu_powered_up(void) return 0; } +static int go_down(unsigned long _arg) +{ + void (*cache_disable)(void) = (void *)_arg; + unsigned int mpidr = read_cpuid_mpidr(); + unsigned int cpu = MPIDR_AFFINITY_LEVEL(mpidr, 0); + unsigned int cluster = MPIDR_AFFINITY_LEVEL(mpidr, 1); + phys_reset_t phys_reset; + + mcpm_set_entry_vector(cpu, cluster, cpu_resume); + setup_mm_for_reboot(); + + __mcpm_cpu_going_down(cpu, cluster); + BUG_ON(!__mcpm_outbound_enter_critical(cpu, cluster)); + cache_disable(); + __mcpm_outbound_leave_critical(cluster, CLUSTER_DOWN); + __mcpm_cpu_down(cpu, cluster); + + phys_reset = (phys_reset_t)(unsigned long)virt_to_phys(cpu_reset); + phys_reset(virt_to_phys(mcpm_entry_point)); + BUG(); +} + +int mcpm_loopback(void (*cache_disable)(void)) +{ + int ret; + + local_irq_disable(); + local_fiq_disable(); + ret = cpu_pm_enter(); + if (!ret) { + ret = cpu_suspend((unsigned long)cache_disable, go_down); + cpu_pm_exit(); + } + local_fiq_enable(); + local_irq_enable(); + return ret; +} + struct sync_struct mcpm_sync; /* diff --git a/arch/arm/mach-vexpress/tc2_pm.c b/arch/arm/mach-vexpress/tc2_pm.c index 29e7785a54..abecdd734f 100644 --- a/arch/arm/mach-vexpress/tc2_pm.c +++ b/arch/arm/mach-vexpress/tc2_pm.c @@ -323,6 +323,26 @@ static void __naked tc2_pm_power_up_setup(unsigned int affinity_level) " b cci_enable_port_for_self "); } +int mcpm_loopback(void (*cache_disable)(void)); + +static void tc2_cache_down(void) +{ + pr_warn("TC2: disabling cache\n"); + if (read_cpuid_part_number() == ARM_CPU_PART_CORTEX_A15) { + /* + * On the Cortex-A15 we need to disable + * L2 prefetching before flushing the cache. + */ + asm volatile( + "mcr p15, 1, %0, c15, c0, 3 \n\t" + "isb \n\t" + "dsb " + : : "r" (0x400) ); + } + v7_exit_coherency_flush(all); + cci_disable_port_by_cpu(read_cpuid_mpidr()); +} + static int __init tc2_pm_init(void) { int ret, irq; @@ -370,6 +390,7 @@ static int __init tc2_pm_init(void) ret = mcpm_platform_register(&tc2_pm_power_ops); if (!ret) { mcpm_sync_init(tc2_pm_power_up_setup); + BUG_ON(mcpm_loopback(tc2_cache_down) != 0); pr_info("TC2 power management initialized\n"); } return ret; Of course it is not because I'm helping you sidestepping firmware problems that I'll stop shaming those who came up with that firmware design. ;-) Nicolas -- To unsubscribe from this list: send the line "unsubscribe linux-samsung-soc" in the body of a message to majord...@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html